Denali Plus CTR1 Installation And Operating Instructions Manual
               | |
Page13 www.DENALIplus.comtemperature limiter will cycle the radiant element on and off to prevent exceeding the maximumsafe surface temperature.Controls & IndicatorsEach of the cooking area controls has an infinite selection of heat settings. The control settingsbegin at low and increase heat output by cycling the heating elements between OFF and fullpower as you turn the knob clockwise. The heating elements will stay at full power for longerperiods and at zero power for shorter periods as you turn the knob clockwise, thus increasing theheat output.There are a series of lights located adjacent to the control knob(s) that provide an indication ofheating element operation and hot surfaces. When a control is in the ON position, a red light is litindicating which burner is on, and hot surface light glows indicating that some part of the glasscooktop surface is too warm too touch or place articles upon. Do not place articles other thancookware on the cooking surface while this light is glowing.CLEANING AND CARETo help ensure that your cooktop stays clean, follow these easy-care tips:• Clean the cooktop before you use it for the first time. A thorough cleaning with a recommendedcooktop cleaner will provide a coating on the cooktop prior to its first use.• Always remove food spills, grease spatters and metal rub-off from cookware. A razor bladescraper or the equivalent works well to remove spillovers.• Clean the cooktop with a paper towel or a clean, soft cloth and a recommended cleaner. Aftercleaning, always wipe the cooktop with a clean, damp cloth to avoid cooked-on cleaner residue.Wipe the cooktop dry.• Do not use a dish towel or sponge to wipe off the cooktop. A film may be left by the detergentand may cause discoloration of the cooktop surface.• Avoid abrasive scouring cleaners of any kind. Also avoid using plastic, nylon or metal cleaningpads. They may scratch or melt onto the cooktop.• Avoid chemical cleaners such as chlorine bleach, ammonia, hydrofluoric acid or chemical ovencleaners. They can etch or discolor the surface.• Do not let anything that melts – plastic, aluminum foil, sugar, etc., come into contact with thecooktop surface when it is hot. Should something melt onto the surface, immediately move it to acool area of the cooktop with a razor blade scraper and then remove it from the cooktop as soonas possible. |
manualsdatabase
Your AI-powered manual search engine