2CERTIFICATE OF CONFORMITYG-Series Cylinder mowers powered by Honda GX Petrol EngineManufacturer:- Howardson Ltd, Howardson Works, Kirk Langley, Derby, DE6 4NJ. UKOwner of Technical Document:- Mr I.D. Howard, Howardson Ltd, Howardson Works Kirk Langley, Derby, DE6 4NJ, UKI the under signed Declare that these machines:-The reliability and quality of performance of the DENNIS G-SERIES depends upon some simple care maintenancecarried out regularly. This manual has been prepared to allow the user to carry out all such work.It is advisable to read the instructions carefully. Proper care and attention will enable the machine to give a continuous,satisfactory, and reliable service. Failure to carry out regular lubrication and maintenance as outlined in this manual mayrender any guarantee or warranty invalid.In the case of any difficulty, or if further information or advice is required, our Service Department is always at your call. Inthe interests of speed and accuracy of information please quote the serial numbers of the machine and engine whenmaking enquiries.For the machine, this is to be found on a plate attached to the side frame. The engine number is stampedon either the crank case or the gear casing facing towards the front of the machine. We suggest you writethe numbers on the front page of this book.INTRODUCTIONSERIAL NUMBERSTested at:- Howardson Works test site September 2011Complies with the applicable requirements of:-- Machine Directive 2006/42/EC- Noise Directive 2000/14/EC (Annex VI Procedure 1)Ian HowardManaging DirectorNOTE:- MAKE A NOTE OF THE SERIAL NUMBER OF YOUR MACHINE AND ALWAYSQUOTE IT IN ANY COMMUNICATION WITH PERSONNEL AT DENNIS.MACHINE SERIAL NUMBERENGINE SERIAL NUMBERModel Cutting Width Power (Honda) Measured Sound Power Level Guaranteed SoundPower Level Serial NumberG26D 26” (660mm) GX160 95 Lwa 98dB Lwa See product ID RangeG30D 30” (760mm) GX160 95 Lwa 98dB Lwa See product ID RangeG34D 34” (860mm) GX200 95 Lwa 98dB Lwa See product ID RangeSP20038_REV0OCTOBER 2017