Denon 3012CI - Power Amplifier Owner's Manual

Contents

Denon 3012CI - Power Amplifier Owner's Manual Manual pdf 20 page image

Getting Started Connections TroubleshootingENGLISHSpecificationsOther OperationsNOTE• When the “POWER CONFIGURATION” is set to “MASTERTRIGGER”, the device will automatically enter the standby statuswhen no trigger input is detected for a period of 10 minutes.• When the “POWER CONFIGURATION” is set to “ON LINE”, senda standby command to the ETHERNET terminal or the RS-232Cterminal of the POA-3012CI.• Power continues to be supplied to some of the circuitry even whenthe power is in the standby mode. When leaving home for longperiods of time or when traveling, unplug the power cord from thepower outlet.Check the Status of Each Channel1 Press the DISPLAY button.b Zone status is indicated on the bottom line of the display.b Turn the SELECT/ENTER knob to change the display as follows.VOLUME CONTROL levelLOW CUT FILTERChannel No. & INPUT LineZONE T.ON MODE2 Press the DISPLAY button again.b System status is indicated on the bottom line of the display.b Turn the SELECT/ENTER knob to change the display as follows.POWER CONFIG DIMMERn To Return to the Regular DisplayPress the u/RETURN button until the display returns to normal.Other Operations During Playbackn To Adjust the VolumeRefer to “VOLUME CONTROL” on the “Main Setup” menu(vpage 13).n To Reduce the Low Frequency VolumeRefer to “LOW CUT FILTER” on the “Main Setup” menu (vpage13).n To Switch Input SettingRefer to “INPUT SELECT” on the “Main Setup” menu (vpage13).Operating the POA-3012CI Using aBrowser (Web control)This function lets you operate the POA-3012CI using InternetExplorer.1 Check the POA-3012CI’s IP Address.“Network Setup” – “Network Information” (vpage 15)2 Input the POA-3012CI’s IP Address in InternetExplorer.For example, if the IP address is “10.3.18.90”, enterhttp://10.3.18.90.3 If the top menu is displayed, click “Setup Menu”.4 When the “Setup Menu” is displayed, click on themenu you want to operate.OperationTurning the Power OnPress the ON/STANDBY button.The power indicator flashes green and the power turns on.b The signal input to each channel is output from the speakerterminal of each channel.b The setting status of each channel is indicated on the display.b Turn the SELECT/ENTER knob to change the channel displayed.CH 1&2BTL BUS L+R0.0dBOutput channel Input terminalOPERATION MODE(No display when in “NORMAL MODE”)Volume leveln To return to STANDBYPress the ON/STANDBY button again.The power indicator lights red.DISPLAYZONE 5ON/STANDBYSELECT/ENTERu/RETURNZONE operation mode indicatorsClickSetup OperationClick the menuCHANNEL SETUP (vExample : 1)SYSTEM SETUP (vExample : 2)WARNING AND PROTECTION DATA(vExample : 3)AUDIO SIGNAL AND TRIGGERINPUT (vExample : 4)OPTION SETUP (vExample : 5)Click “SAVE” when you want to save settings,and click “LOAD” when you want to call settingsBecomes each operation screen