179 USING THE REMOTE CONTROL UNITFollowing the procedure outlined below, insert the batteries before using the remote control unit.Range of operation of the remote control unitInserting the batteriesPoint the remote control unit at the remote control sensor as shownon the diagram at the left.NOTES:• The remote control unit can be used from a straight distance ofapproximately 23 feet/7 meters, but this distance will shorten oroperation will become difficult if there are obstacles between theremote control unit and the remote control sensor, if the remotecontrol sensor is exposed to direct sunlight or other strong light, orif operated from an angle.• Neon signs or other devices emitting pulse-type noise nearby mayresult in malfunction, so keep the set as far away from suchdevices as possible.Approx. 23 feet/7 m30°30°w Insert the R6P/AA batteries properly, asshown on the diagram.q Press as shown by the arrow and slide off. e Close the lid.NOTES:• Use only R6P/AA batteries for replacement.• Be sure the polarities are correct. (See the illustration inside the battery compartment.)• Remove the batteries if the remote control transmitter will not be used for an extended period of time.• If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean thebattery compartment thoroughly before installing new batteries.• Have replacement batteries on hand so that the old batteries can be replaced as quickly as possible when the time comes.• Even if less than a year has passed, replace the batteries with new ones if the set does not operate even when the remote control unit isoperated nearby the set. (The included battery is only for verifying operation. Replace it with a new battery as soon as possible.)ENGLISH