106ENGLISHCheck again before assuming the player is malfunctioning2 Are all the connections correct ?2 Are you following the instructions in the manual ?2 Are the speakers and other components operating properly ?If this unit does not seem to be functioning properly, check the table below. If this does not solve the problem, this unit may be damaged. Turnoff the power, unplug the power cord from the power outlet, and contact your store of purchase or nearest Denon sales office.23 TROUBLESHOOTINGSymptom Cause Measures PageDISPLAY not lit and sound not producedwhen power switch set to on.• Power cord not plugged in securely. • Check the insertion of the power cord plug. 10DISPLAY lit but sound not produced.• Speaker cords not securely connected.• Improper position of the audio functionbutton.• Volume control set to minimum.• MUTING is on.• Digital signals not input Digital inputselected.• Connect securely.• Set to a suitable position.• Turn volume up to suitable level.• Switch off MUTING.• Input digital signals or select input jacks towhich digital signals are being input.1044424647Monitor doesn’t display an image.• Connections between the video output jackof this unit and the input connector of themonitor are incomplete.• The input setting of the monitor TV isdifferent.• When “PROGRESSIVE” is set, no videosignals are output from the VIDEO OUT orS-VIDEO OUT terminals.• Check whether the connections are correct.• Set the input switching of the TV to the jackto which the video input is connected.• Set “INTERLACED” if you want to use theVIDEO OUT or S-VIDEO OUT signals.13—40The program cannot be copied from DVDto the VCR.• Almost all movie software contains a copyprevention signal.• A copy cannot be made. —The subwoofer does not produce sound.• Power is not being supplied to thesubwoofer.• The subwoofer setting is made to “No” inthe setup.• The output of the subwoofer has not beenconnected.• Switch on the power of the subwoofer.• Change the setting to “Subwoofer” in thesetup.• Make the proper connections.—3110This unit does not operate properly whenremote control unit is used.• Batteries dead.• Remote control unit too far from this unit.• Obstacle between this unit and remotecontrol unit.• Different button is being pressed.• < and > ends of battery inserted in reverse.• The mode selection of the remote control isnot properly selected. The DVD mode, AVmode, or audio mode is not properlyselected.• Replace with new batteries.• Move closer.• Remove obstacle.• Press the proper button.• Insert batteries properly.• Press the remote control mode selectionbutton for the item you wish to operate. Tooperate this unit, use with the DVD mode.232323192324Remote control unit Common problems when listening to the discs, tapes and FM broadcasts, etc.