6AVR-2307CI / AVR-2307 / AVR-887 / AVC-1930VIDEO Section1. SETTING(1) Connect the oscilloscope to the Y-signal and C-signal ofS MONITOR OUT terminal and each terminate at 75Ohms.(2) Connect the oscilloscope to the Y-signal, P B-signal andCB -signal, PR -signal and C R -signal of COMPONENTMONITOR OUT terminal and each terminate at 75Ohms.Use the 75 Ohms resistance must be 1%(3) DVD test disc : DVDT-S01(4) COMPONENT VIDEO OUT of DVD player is connectedto COMPONENT IN-1.2. BEFORE ADJUSTMENT2.1. Setting the Oscilloscope as below.(1) P B /CB , PR /CR , C(a) TIME/DIV : 10 s(b) VOLT/DIV : 100mV(Use the probe : x10 )(2) Y(a) TIME/DIV : 10 s(b) VOLT/DIV : 200mV(Use the probe : x10 )Power SupplyUSA & Canada & Taiwan R.O.C.: 120VEurope & Asia : 230VJapan : 100VChina & Korea : 220V2.2. Setup the DVD player and confirmation of thestators(1) Set to "INTERLACED" mode at the COMPONENT OUT.(2) Confirm the DVD player’s out put level is equal as theitem 2.4. in following.2.3. Preparation(1) • For E3/E1C/EUT/JP model :Push [POWER] button with pressing [VIDEO SELECT]and [STATUS] buttons.• For E2/E2A model :Push [POWER] button with pressing [RDS] and [RT] but-tons.(2) Confirm "0.0dB" appearing on the FL display.(3) Turn the FUNCTION knob to select "DVD" input.(4) Push [PURE DIRECT] button of Remote Control Unit toselect "PURE ". (FL display disappears and becomesadjustment mode.)(5) Push [OPEN/CLOSE] button of DVD player, then openthe Disc Tray.Set DVD test disc (DVDT-S01) on the Disc Tray, andthen push [CLOSE] button.(6) DVD player FL display appear "STOP", push [PLAY] but-ton to playback DVD.(7) Push the [DISPLAY] button of remote control of DVDplayer unit and then appear the ON-Screen Display (GUI)on the monitor TV.(8) Push the [+10] and [2] button, select Title 12 of DVD.(9) Push the [ENTER] button, playback Title 12.(color bar 75%)6