13GUI Menu MapSetupInformationTroubleshooting[TUNINGd f][SIRIUS][CHANNEL + / –][SHIFT][ENTER][OPTION][uio p]Device operatedAUX-1(SIRIUS)Zone selectionMZ2Z3Z4(b)SOURCE SELECTInput source selectionCHANNEL + / –Preset channel selection–SHIFTPreset channel memoryblock selection–uiopCategory search–ENTERParentalLock (press and hold)–OPTIONPreset Memory–TUNINGdfChannel selection–Functions of Buttons by Componentb:In ZONE4, it is not possible to select “XM”, “HD Radio” or sourceswith no digital input signals (“TUNER”, “PHONO”, “iPod”, etc.).Network audio signals (Internet radio, music server, USB) can beplayed as long as they are not copyright-protected.Sub Remote Control Unit OperationsParental Lock1Tune to the channel you want to lock.2Press[ENTER]for at least 3 seconds.“Code: [ ]” is displayed.3Enter the 4-digit lock code usinguiop.When you enter the correct code, the corresponding channel islocked.4Press[ENTER].•Channels under Parental Lock cannot be tuned in by performingTuning Up/Down or by category search.•Channels stored in preset memory can be tuned in by the presetchannel select operation, even if Parental Lock is applied.•When a channel to which Parental Lock is applied is being played,Parental Lock for that channel is cancelled by performing Step 2.•See “Edit Lock Cord” (vpage 6) for the method of changingParental Lock Cord.•You can also set “Parental Lock” from the GUI menu (vpage 6).•“UPDATING” is displayed while the channel list is being updated.•“SIRIUS UPDATING” is displayed when updating SIRIUS tunerfirmware.•Refer to “Troubleshooting” – “SIRIUS Satellite Radio” regardingother messages (vpage 18).1Press[SEARCH].2Press[NUMBER (0 ~ 9)]to input the channel.Example:Accessing channel “SR123”:[1]→[2]→[3]bIf no button is pressed within several seconds, the channelautomatically switches to the one whose number has been input.3Press[ENTER]to set that channel.Reception switches to the selected channel.Accessing SIRIUS Satellite RadioChannels DirectlyListening to Preset Channels1Press[CHANNEL + –].A pop-up window appears.2Select a preset channel using[CHANNEL + –].3Press[ENTER].Operation on the Main Remote control UnitOperation on the Main UnitPress, then turnto select the preset channel.3Press[A ~ G]to select the block in which the channelis to be preset.4Press[CHANNEL + –]or[NUMBER (1 ~ 8)]to selectthe preset number.5Press[MEMO]again to complete the setting.To preset other channels, repeat steps 1 to 5.NOTEPreset channels are erased by overwriting them.Searching Categories1Pressop.SR001Hits1CAT:Pops2Useopto select the category, to useuito selectthe desired channel.Channel categorySelection is still possible if you press[1 ~ 8]after pressing[A ~ G].Playback