7GUI Menu MapSetupInformationENGLISH[iPod][SEARCH][POWER OFF][CHANNEL + –]ENTERuio p[8], [9],[6], [7],[1], [2]uio pENTERPreparationsTurning the Power On[SOURCESELECT][POWER ON][AMP][iPod][QUICK SELECT]1Press.The power indicator lights red and the power is set to thestandby mode.2Pressor[POWER ON].The power indicator fl ashes green and the power turns on.bAlso press[SOURCE SELECT]when in standby mode, the powerturns on. In this case the input source is selected by main remotecontrol unit.bAlso press[QUICK SELECT]when in standby mode, the powerturns on. In this case Quick Select is selected.PlaybackButton located on both the main unitand the remote control unitBUTTONButton only on the main unitButton only on the remote control unit[BUTTON]Symbols used to indicate buttons in this manualiPod® PlaybackThe music on an iPod can be played by using the Control Dock foriPod (ASD-1R or ASD-11R, sold separately).The operation can also be performed using the buttons on the mainunit or remote control unit while watching the GUI menus.iPod is a trademark of Apple Inc., registered in the U.S.and other countries.bThe iPod may only be used to copy or play contents that are notcopyrighted or contents for which copying or playback is legallypermitted for your private use as an individual. Be sure to complywith applicable copyright legislation.1Make the necessary preparations.qSet the iPod in the DENON Control Dock for iPod.(vSee the Control Dock for iPod’s operating instructions.)wAssign the Control Dock for iPod’s input.wAssign the Control Dock for iPod’s input.:”Source Select”–“(input source)”–“Assign”–”iPod dock”Basic Operation2Either turnor press[iPod](AMPmode) to select the input source assigned in step 1-wabove.– GUI screen –Music[1/6]PlaylistsArtistsAlbumsSongsComposersGenresiPod[1/2]MusicVideos(When using an ASD-1R)(When using an ASD-11R)bWhen using the ASD-11R, “Music” and “Videos” folders appearin the Top menu.bWhen communication between AVP-A1HD / AVC-A1HD and iPodis complete, the relevant GUI screen is displayed. If the screenis not displayed, the iPod may not be properly connected. Tryconnecting again.connecting again.:”Source Select”–“(input source)”–“Play”3To operate using the main remote control unit, set theremote control unit to the iPod mode.4Press[SEARCH]and hold it down for a 2 seconds ormore to select the display mode.To switch between modes, press and hold down the button.When remote mode is active, “Remote” is displayed.[Display mode]Browse modeRemote modeDisplay locationMain unit displayiPod displayPlayablefilesAudio fileSSVideo fileSz1Sz2ActivebuttonsRemotecontrol unit(AVP-A1HD /AVC-A1HD)SSiPodASz1: When using an ASD-11R control dock for iPod.z2: Video may not be output, depending on the combination ofASD-1R and iPod.[REPEAT][8][2][RANDOM][SEARCH][9][1/3](Main remote control unit)(Sub remote control unit)Playback
