28ENGLISHPreset memoryDENON and other makes of components can be operated by setting the preset memory.This remote control unit can be used to operate components of other manufacturers without using the learning function by registering themanufacturer of the component as shown on the List of Preset Codes (pages 122~126).Operation is not possible for some models.12Set mode switch 1 to “AUDIO” or “VIDEO”.Set mode switch 2 to the component to be registered.3214Set the AUDIO side for the CD, Tape deck or CDR/MDposition, to the VIDEO side for the DVD/VDP, DBS/CABLE,VCR or TV position.3 Press the ON/SOURCE button and the OFF button at thesame time.• Indicator flash.45Referring to the included List ofPreset Codes, use the numberbuttons to input the preset code (a3-digit number) for the manufacturerof the component whose signalsyou want to store in the memory.To store the codes of another component in the memory,repeat steps 1 to 4.The preset codes are as follows upon shipment from the factory and after resetting:TV, VCR.....................................................HITACHICD, TAPE ..................................................DENONCDR/MD ...................................................DENON (CDR)DVD/VDP ..................................................DENON (DVD)DBS/CABLE ..............................................ABC (CABLE)NOTES:• The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote controlunit’s transmitting window while setting the preset memory.• Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed on theincluded list of preset codes.• Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number andcheck.• The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP and DBS/CABLE.1 2 34 5 67 8 90