Denon AVR-1712 Owner's Manual

Also see for AVR-1712: Specifications Getting started Owner's manual Service manual Quick start guide

Denon AVR-1712 Owner's Manual Manual pdf 45 page image

42Convenient functionsNOTE• When “HDMI Control” is set to “ON”, it consumes morestandby power.• The HDMI control function controls operations of a TV that iscompatible with the HDMI control function. Make sure that the TVand HDMI are connected when you perform HDMI control.• Some functions may not operate depending on the connected TVor player. Check the owner’s manual of each device for detailsbeforehand.• When “P.Off Control” on the menu is set to “OFF” (vpage 63),this unit is not set to standby even if the connected device is in thestandby mode.• When connection changes are implemented, such as addingconnections to HDMI devices, linked operations may be initialized.In this case, you will need to reconfigure the settings.• When “HDMI Control” is set to “ON”, it is not possible to assign anHDMI connector to “TV” at “Input Assign” (vpage 70).• Should any of the operations below be performed, the interlockingfunction may be reset, in which case, repeat steps 2 and 3.• “Input Assign” – “HDMI” (vpage 70) setting has changed.• There is a change to the connection between the devices and theHDMI, or an increase in devices.Sleep timer functionThe power automatically goes into standby once the set time haselapsed.This is convenient for playing sources while going to sleep.Press SLEEP and display the time youwant to set.The “SLEEP” indicator on the display lights.• The time switches as shown below eachtime SLEEP is pressed.OFF 10 min 20 30 40 506080 7090100110120• If SLEEP on the main unit is pressed, the same function as with theremote control unit can be obtained.To confirm the countdown time before putting theunit to sleepPress SLEEP.“Sleep : zmin” appears on the display.z Countdown timeTo cancel the sleep timerPress SLEEP to set “OFF”.The “SLEEP” indicator on the display turns off.• The sleep timer setting is canceled if this unit’s power is set tostandby.• The sleep timer function can be set separately for the different zones(vpage 46 “Sleep timer function”).