Denon AVR-2308CI Owner's Manual

Also see for AVR-2308CI: Comparison chart Specifications Manual Manual Dimensions

Denon AVR-2308CI Owner's Manual Manual pdf 53 page image

0Getting Started Connections Setup Playback Multi-Zone Information TroubleshootingENGLISHRemote Control Unit OperationsDepending on the model and year of manufacture of your equipment,some buttons may not operate.[MODESELECTOR 1][MODESELECTOR 2]1 Set [MODE SELECTOR 1] to “AUDIO”.2 Set [MODE SELECTOR 2] to the position for thecomponent to be operated (CD, iPod/NETWORK orTAPE/CD-R/MD).3 Operate the audio component.b For details, refer to the component’s operating instructions.b While this remote control is compatible with a wide range ofinfrared controlled components, it may be the case that somecomponent models cannot be operated with this remote control.1 Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.b Set to the AUDIO side for the CD or TAPE/CD-R/MD position,and to the VIDEO side for the DVD/VDP, SAT/CABLE, VCR or TVposition.2 Set [MODE SELECTOR 2] to the component to beregistered.3 Press [ZONE2 OFF] and [MAIN ON] at the same time.The indicator starts flashing.4 Referring to the included list of preset codes, press[NUMBER] to input the preset code (a 3-digit number)for the manufacturer of the component whose signalsyou want to store in the memory.5 To store the codes of another component in thememory, repeat steps 1 to 4.• The signals for the pressed buttons are emitted while setting thepreset memory. To avoid accidental operation, cover the remotecontrol unit’s transmitting window while setting the preset memory.• Depending on the model and year of manufacture, this functioncannot be used for some models, even if they are of makes listed inthe list of preset codes.• Some manufacturers use more than one type of remote control code.Refer to the included list of preset codes to change the number andverify correct operation.• The preset memory can be set for one component only among thefollowing: TAPE/CD-R/MD, DVD/VDP and SAT/CABLE.1 Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.b Set to the AUDIO side for the CD or TAPE/CD-R/MD position,and to the VIDEO side for the DVD/VDP, SAT/CABLE, VCR or TVposition.2 Set [MODE SELECTOR 2] to the component you wantto operate.3 Operate the component.b For details, refer to the component’s operating instructions.b Some models cannot be operated with this remote control unit.Main Remote Control UnitOperating DENON Audio ComponentsPresetting• DENON and other makes of components can be operated bysetting the preset memory.• This remote control unit can be used to operate componentsof other manufacturers without using the learning function byregistering the manufacturer of the component as shown in thelist of preset codes (vEnd of this manual).• Operation is not possible for some models.Operating Preset Components[ZONE2 OFF][NUMBER][MAIN ON][Front][Rear]Remote Control