Denon AVR-2805 Operating Instructions Manual

Also see for AVR-3805: Control protocol Service manual Service manual Operating instructions Operating instructions

Contents

Denon AVR-2805 Operating Instructions Manual Manual pdf 6 page image

_'1 CONNECTIONS• Do not plug in the AC cord until all connections have beencompleted.• Be sure to connect the left and right channels properly (left withleft, right with right).• Insert the plugs securely. Incomplete connections will result in thegeneration of noise.• Use the AC OUTLETS for audio equipment only. Do not usethem for hair driers, etc.•Nete that binding pin plug cords together with AC cords or placingthem near a power transfermer will result in generating hum erother noise.• Neise or humming may be generated if a connected audioequipment is used independently without turning the power of thisunit on. If this happens, turn on the pewer of the this unit.• When making connections, also refer to the operating instructiens of the other components.OUTPUT CD playerR LTurntable(MM cartddge/ [ Connecting a turntable ]Connect the turntable's output cord to the AVR-2805/985's PHONO jacks, the L (left) plug to the Ljack, the R (dght/plug to the right jack.NOTE:__la yi er"_t_.c_gepThisunit cannot be used with MC cartridgesdirectly. Use a separate head amplifier or step upIf humming or other noise is generated when theground wire is connected, disconnect the groundwire._ Ground wireI Connecting the AC OUTLETS tAC OUTLETSSWITCHED(total capacity - 120 W (1 A.)/The power to these outlets is turned on and off in conjunction with thePOWER operation switch on the main unit, and when the power is switchedbetween on and standby from the remote control unit.driers, TVs or other electrical appliances.Connecting the pre-out jacksUse these jacks if you wish to connect external power amplifier(s) toincrease the power of the front, center and surround sound channels, orfor cor/nectior/ to powered loudspeakers.•_ To use Surround back with one speaker, connect the speaker toMD recorder, CD recorder or other componentOPTICAL _ R LINPUTI Connecting the DIGITAL jacks IUse these for connections to audio equipment with digital output Refer to "Setting theDigital in Assignment" (See page 37)NOTES:R LOUTPUTAC 120 V, 60 HzTurn the DC 12V voltage on and off for the individual functions.For details, see "Setting the Tdgger Setup" (See page 441CD recordel or Tape deck83oo _oI Connecting a tape deck IConnections for recording:Connect the tape deck's recording input jacks (LINE Hq or REC/to tMs Uilit's taperecording (CDR/TAPE OUT/jacks using pin plug cords.Connections for playback:Connect the tape deck's playback output jacks (LINE OUT or PB) to this unit's tapeplayback (CDR/TAPE IN/jacks using pin plug cords