3215 LISTENING TO THE RADIOAuto tuning12 33 Press the TUNING + or – button.• Automatic searching begins, then stopswhen a station is tuned in.1 32NOTE:• When in the auto tuning mode on the FM band, the “STEREO” indicator lights on the display when a stereobroadcast is tuned in. At open frequencies, the noise is muted and the “TUNED” and “STEREO” indicatorsturn off.Manual tuning1 Set the input function to “TUNER”.3 Press the BAND button to set the manualtuning mode.Check that the display’s “AUTO” indicatorturns off.4 Press the TUNING + or – button to tune in thedesired station.The frequency changes continuously when thebutton is held in.2 Watching the display, press the BAND buttonto select the desired band (AM or FM).NOTE:• When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the “STEREO”indicator turns off.1 Set the input source to “TUNER”.2 Watching the display, press the BAND buttonto select the desired band (AM or FM) and toset the auto tuning mode.FUNCTION / SELECTBAND(Main unit) (Remote control unit)(Main unit) (Remote control unit)(Remote control unit)ENGLISHTUNING(Main unit)Preset stationsPreparations:Use the “Auto tuning” or “Manual tuning” operationto tune in the station to be preset in the memory.1 Press the MEMORY button.2 Press the SHIFT button andselect the desired memoryblock (A to E).4 Press the MEMORY buttonagain to store the station inthe preset memory.To preset other channels, repeat steps 1 to 4.A total of 40 broadcast stations can be preset – 8stations (channels 1 to 8) in each of blocks A to E.3 Press the CHANNEL + or –button to select the desiredpreset channel (1 to 8).NOTE:• Please make sure the “AUDIO” position ofthe slide switch on the remote control unit.1,432(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)A 1 FM 87.50MDisplay LitFUNCTION / SELECT(Main unit) (Remote control unit)BAND(Main unit) (Remote control unit)BAND(Main unit) (Remote control unit)(Remote control unit)TUNING(Main unit)