Denon AVR-589 Owner's Manual

Also see for AVR-589: Product Compatibility Chart Getting started Comparison chart Service manual Getting started

Denon AVR-589 Owner's Manual Manual pdf 33 page image

Plug the headphones into the PHONES jack on the mainunit.The sound from the speakers and pre-out connectors is automaticallycut.NOTEBe careful not to set the volume too high when using headphones.Listening with HeadphonesPress .Switching the front speakersVideo Select FunctionSwitch video input source while listening to audio signal.Press VIDEO SELECT until the desired picture appears.b To cancel, press VIDEO SELECT to select “SOURCE”.b To operate from the remote control unit, be sure to set the[SOURCE CONTROL 1] to “AUDIO”.Playing Video and AudioEquipment1 Prepare the equipment.q Load the DVD, CD or other software in the player.(vSee the operating instructions of the respective devices.)w To play a video device, switch the monitor input.(vSee the monitor’s operating instructions.)2 Use SOURCE SELECT to select the input source.3 Start playback.(vSee the operating instructions of the respective devices.)Basic OperationPress [MUTING].• The sound is reduced to the level set at “System Setup” – “OptionSetup” – “Mute Level”.• To cancel, press [MUTING] again. Muting can also be canceled byadjusting the master volume.Turning Off the Sound Temporarily (Muting)Press .The current program source and various settings are indicated onthe display.For details, refer to “Information” (vpage 29).Checking the currently playing program source, etc.Switching the brightness of the displayPress .Bright DimDarkOFFThe remote control unit can be used to operate external devices.See “Remote Control Unit Operations” (vpage 36).When setting to “OFF”, the display brightness of the menu setting inoperation changes to “Dark”.Getting Started Connections Setup Playback Remote Control Information Troubleshooting Specifications1 Either turn or press [TUNER] toselect “TUNER”.2 Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCECONTROL 2] to “TUNER”.(vpage 36 “Remote Control Unit Operations”)3 Press BAND to select “FM” or “AM”.4 Tune in the desired broadcast station.q To tune in automatically (Auto Tuning)Press [MODE] to light the “AUTO” indicator on the display, thenuse TUNING to select the station you want to hear.w To tune in manually (Manual Tuning)Press [MODE] to turn off the display’s “AUTO” indicator, then useTUNING to select the station you want to hear.Listening to FM/AM Broadcasts• If the desired station cannot be tuned in with auto tuning, tune it inmanually.• When tuning in stations manually, press and hold TUNING to changefrequencies continuously.Basic OperationPresetting Radio Stations(Preset Memory)Your favorite broadcast stations can be preset so that you cantune them in easily. Up to 56 stations can be preset.1 Tune in the broadcast station you want to preset.2 Press [MEMORY].3 Press SHIFT to select the block (A to G) in which thestation is to be preset.4 Press or [CHANNEL + –] toselect the preset number (1 to 8).5 Press [MEMORY] again to complete the setting.• To preset other stations, repeat steps 1 to 5.• Stations can be preset automatically at “System Setup” – “InputSetup” – “Auto Preset Memory” (vpage 22).NOTEPreset stations are erased by overwriting them.