ENGLISH22Setting the type of speakers• Set up in function of your speaker systems. Performing this setup optimizes the system.• The composition of the signals output to the different channels and the frequency response are adjusted automatically according to thecombination of speakers actually being used.1 Set whether or not speakers are connected and, if so, their sizeparameters.• To select the speaker• To select the parameter2 Press the ENTER or (down) button to enter the settings and switch to the SUBWOOFER MODEsetting.Center Sp. Front Sp.Front Sp.SubwooferSurround Sp.Listening positionSurround Sp.Surround back Sp.1 FRONT LARGE• ParametersLarge…… Select this when using speakers that can fully reproduce low sounds of below 80 Hz.Small…… Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient volume. When this setting isselected, low frequencies of below 80 Hz are assigned to the subwoofer.None…… Select this when no speakers are installed.Yes/No…. Select “Yes” when a subwoofer is installed, “No” when it’s not installed.NOTE:Select “Large” or “Small” not according to the physical size of the speaker, but according to the bass reproduction capacity at 80 Hz. If you cannotdetermine the best setting, try comparing the sound when set to “Small” and when set to “Large”, at a level that will not damage the speakers.Caution:In case the subwoofer is not used, be sure to set “Subwoofer = No”, or the bass sound of front channel is divided to subwoofer channel andnot reproduced in some mode.If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when “Small” is set for the front, centerand surround speakers.For the majority of speaker system configurations, using the Small setting for all five main speakers and Subwooofer On with a connectedsubwoofer will yield the best results.