Input SelectSet the audio input mode and decode mode of each input source.The input modes available for selection may vary depending on the inputsource.0 “Input Select” settings are stored for each input source.o Input ModeSet the audio input modes for the different input sources.It is normally recommended to set the audio input mode to “Auto”.Auto(Default):Automatically detect input signal andperform playback.HDMI: Play only signals from HDMI input.Digital: Play only signals from digital audio input.Analog: Play only signals from analog audio input.0 When digital signals are properly input, the ~ indicator lights on the display.If the ~ indicator does not light, check “Input Assign” and the connections.(v p. 181)0 If “HDMI Control” is set to “On” and a TV compatible with the ARC isconnected via the HDMI MONITOR connectors, the input mode whose inputsource is “TV Audio” is fixed to ARC.o Decode ModeSet the audio decode mode for input source.It is normally recommended to set the audio input mode to “Auto”. Butwe recommend changing it to “PCM” or “DTS” if the start of the sourceis clipped or noise occurs.Auto(Default):Detect type of digital audio input signaland decode and play automatically.PCM: Decode and play only PCM input signals.DTS: Decode and play only DTS input signals.0 This item can be set for input sources for which “HDMI” or “DIGITAL” isassigned at “Input Assign”. (v p. 181)Contents Connections Playback Settings Tips Appendix185Front panel Display Rear panel Remote IndexDownloaded from www.Manualslib.com manuals search engine
