Speaker connectionHere we connect the speakers in the room to this unit.This section explains how to connect them using typical examples.NOTE0 Disconnect this unit’s power plug from the power outlet before connecting thespeakers. Also, turn off the subwoofer.0 Connect so that the speaker cable core wires do not protrude from the speakerterminal. The protection circuit may be activated if the core wires touch the rearpanel or if the + and - sides touch each other. (“Protection circuit” (v p. 119))0 Never touch the speaker terminals while the power cord is connected. Doing socould result in electric shock. When the “Setup Assistant” (page 8 in the separate“Quick Start Guide”) is running, follow the instructions in the “Setup Assistant”screen for making connections. (Power is not supplied to the speaker terminalswhile the “Setup Assistant” is running.)0 Use speakers with an impedance of 6 – 16 Ω/ohms.o Connecting the speaker cablesCarefully check the left (L) and right (R) channels and + (red) and –(black) polarities on the speakers being connected to this unit, and besure to connect the channels and polarities correctly.1 Peel off about 10 mm of sheathing from the tip of thespeaker cable, then either twist the core wire tightly orterminate it. .2 Press the lever on the speaker terminal. .3 Holding the lever on the speaker terminal, insert thecore wire of the speaker cable all the way into thespeaker terminal. .4 Release your finger from the lever on the speakerterminal. .Contents Connections Playback Settings Tips Appendix22Front panel Display Rear panel Remote Index
