Operating learning functionIf the device does not operate even when the preset code is registered,use the learning function. Remote codes for different devices can beremembered for use by the Denon remote control included with thisdevice.o Remembering remote control codes fromother devices1 Press and hold RC SETUP for more than 3 seconds.“SETUP” and p indicator flashes twice on the remote control unit.2 Use ui to display “LEARN” on the remote control unitand press ENTER.3 When “DEVIC” appears on the remote control unit,press the input source select button of the AVequipment that you want to store.0 You cannot store the remote control code in the AVR button.0 Before using the learning function, register a preset code for amode other than AVR preset to each input source switch button.(“Registering preset codes” (v p. 270))4 When “KEY” appears on the remote control unit, pressthe button that you want to store.5 When “READY” appears on the remote control unit,place the remote control unit of the AV equipment faceto face with main remote control unit (of this unit).Next, press and hold down the desired button (that youwant to store) of the remote control unit of the AVequipment. .0 When the button is correctly stored, “OK” flashes four times onthe remote control unit.0 If the button is not correctly stored, “FAIL” flashes four times onthe remote control unit. If this happens, perform step 4 again.Contents Connections Playback Settings Tips Appendix277Front panel Display Rear panel Remote Index
