Denon DCD-1520AE Owner's Manual

Also see for DCD-1520AE: Owner's manual Getting started Getting started User manual

Contents

Denon DCD-1520AE Owner's Manual Manual pdf 54 page image

54AppendixSettingsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteTipsTroubleshootingIf a problem should arise, first check the following:1. Are the connections correct?2. Is the set being operated as described in the owner’s manual?3. Are the other devices operating properly?If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.In this case, disconnect the power immediately and contact your store of purchase.2 Power does not turn on / Power is turned offSymptom Cause / Solution PagePower is not turned on. • Check whether the power plug is correctly inserted into the power outlet.• This unit is in standby mode. Press POWER X on the remote control.2527Power automatically turns off. • The Auto Standby mode is set. When Auto Standby mode is set to On, if the unit remains in thestopped state and no operations are performed or if there are no input signals for approximately 30minutes, the unit automatically switches to standby mode.512 Operations cannot be performed through the remote control unitSymptom Cause / Solution PageOperations cannot be performedthrough the remote control unit.• Batteries are worn out. Replace with new batteries.• Operate the remote control unit within a distance of about 8 m from this unit and at an angle ofwithin 30°.• Remove any obstacle between this unit and the remote control unit.• Insert the batteries in the proper direction, checking the q and w marks.• The set’s remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescentbulb light, etc.). Move the set to a place in which the remote control sensor will not be exposedto strong light.• When using a 3D video device, the remote control unit of this unit may not function due to effectsof infrared communications between units (such as TV and glasses for 3D viewing). In this case,adjust the direction of units with the 3D communications function and their distance to ensure theydo not affect operations from the remote control unit of this unit.• Press REMOTE MODE CD button to switch the remote control to the CD operation mode.55–5––12Downloaded from www.Manualslib.com manuals search engine