Denon DCM-5000 Specification

Also see for DCM-5000: Datasheet Operating instructions

Contents

.14 Cross Fade PlayThis command starts reproduction in the Cross Fade Play mode.This command is valid only in the Cross Fade mode. This command can be used only when theCross Fade mode is set and reproduction is required. Use the Cross Fade Disc Reserve commandto reserve the next disc after the Cross Fade reproduction starts.bytebit 7 6 5 4 3 2 1 00 STX02h1 Command code (‘X’)2 Disc number (100 digits)3 Disc number (10 digits)4 Disc number (1 digits)5 Track number (10 digits)6 Track number (10digits)7 Next disc number (100 digits)8 Next disc number (10 digits)9 Next disc number (1 digits)10 Next track number (10 digits)11 Next track number (1 digits)12 ETX03h13 BCCH (high-level)14 BCCL (low-level)(1) Answers returnedbytebit 7 6 5 4 3 2 1 00 STX02h1 Reply code (‘X’)2 Answer code3 ETX03h4 BCCH (high-level)5 BCCL (low-level)(2) Special condition• Specify a disk number and a track number that are present and available as the parameters. The discnumber (byte 2 to byte 4) must not be equal to the next disc number (byte 2 to byte 9).• This command is enabled only when the system status is Disc SenseComplete (3) and when the zone status is No Disc (A) or Stop (B).• In case the Cross Fade Disc Reserve command cannot be submitted as thecommand submission conditions are not satisfied (in the Auto Pause status), this command canstarts cross fade reproduction.(3) Other