Denon DHT-500SD Operating Instructions Manual

Denon DHT-500SD Operating Instructions Manual Manual pdf 12 page image

12ENGLISHFrequencyRDS : Use this button to automaticallytune to stations using the radio datasystem.3 [3] Tuner system buttons(Operated with mode switch 2 set to“TUNER”)+-+-+-- +- +RC-973A / VA-B REPEATONOFFREPEAT RANDOMCLEAR ZOOMPROG/DIRECTMEMO BANDMODESTATUSRETURNANGLE AUDIO SUB TITLESETUP TONE /DIMMERFUNCTIONSURROUNDINPUT MODETEST TONEDVDTUNERCH3216549870 /10ENTERMUTING+10DISPLAY MENU TOP MENUTUNER TV / VCRNTSC/PALSLEEPTV INTUNING /TV VOLTV CH TV CHVCR CHAV AMPDVDVCR PWR PWRTVPBCCALLSURROUNDSURROUNDPARARAMEAMETERTERCH SELECTCT RTPTYRDSTVDVD TUNERVIDEO 1 VIDEO 2BAND : FM/AM band selectionMEMO : Preset memoryMODE : FM auto/mono modeselectionTUNER +/– : Tuning up/down1 ~ 10, +10 : Preset channel numberbuttonsRDS PTY TP1 1 1OFF 0PTY : Press this button afterselecting“PTY” with the RDSbutton to select one of the 29program types.CT : Use this to correct the time of theclock on the ADV-500SD. Press thisbutton when the time service of anRDS station is being properlyreceived. “TIME” is displayed for 2seconds and the ADV-500SD’s clockis corrected. “NO DATA” isdisplayed if the RDS station doesnot offer a time service and whenthe broadcast is not being receivedproperly.RT : Press this button when receivingRDS stations to select thefrequency, PS (or Station name),PTY or RT display.Note that this button will notfunction if the reception is poor.The display mode changes asfollows each time the button ispressed.PS (or Station name) RTPTY1 10The station name is displayed with priorityinstead of the PS display when a channelwhose station name has been preset istuned in.09 REMOTE CONTROL UNIT• The included remote control unit (RC-973) can be used to operate not only this unit but other remote controlcompatible DENON components as well. In addition, the memory contains the control signals for other remotecontrol units, so it can be used to operate non-DENON remote control compatible products.(1) Inserting the batteriesq Remove the remote control unit’s rear cover.w Set three R6P/AA batteries in the battery compartment in the indicated direction.e Put the rear cover back on.Notes on Batteries• Use R6P/AA batteries in the remote control unit.• The batteries should be replaced with new ones approximately once a year, though this depends on thefrequency of usage.• Even if less than a year has passed, replace the batteries with new ones if the set does not operate evenwhen the remote control unit is operated nearby the set. (The included battery is only for verifyingoperation. Replace it with a new battery as soon as possible.)• When inserting the batteries, be sure to do so in the proper direction, following the < and > marks in thebattery compartment.• To prevent damage or leakage of battery fluid:• Do not use a new battery together with an old one.• Do not use two different types of batteries.• Do not short-circuit, disassemble, heat or dispose of batteries in flames.• Remove the batteries from the remote control unit when you do not plan to use it for an extended periodof time.• If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insertnew batteries.• When replacing the batteries, have the new batteries ready and insert them as quickly as possible.(2) Using the remote control unitSTANDBYDVDP.SCANDEXTITLECHPDVD SURROUND RECEIVER ADV-500SDPHONESMASTER VOLUME/SELECTMEMORYBANDFM MODETONE/DIMMERFUNCTIONON/STANDTUNINGPROGRESSIVESCANSURROUNDMODE+-+-+--+-+RC-973A / VA-B REPEATONOFFREPEATRANDOMCLEARZOOMPROG/DIRECT MEMOBANDMODESTATUSRETURNANGLEAUDIOSUB TITLESETUPTONE /DIMMERFUNCTIONSURROUNDINPUT MODETEST TONEDVDTUNERCH321 654 9870 /10ENTERMUTING+10DISPLAYMENUTOP MENUTUNER TV / VCRNTSC/PALSLEEPTV INTUNING /TV VOLTV CHTV CHVCR CHAV AMPDVDVCR PWRPWRTVPBCCALLSURROUNDSURROUNDPARARAMEAMETERTERCH SELECTCTRTPTYRDSTVDVDTUNERVIDEO 1VIDEO 2-+-+--+MEMOBANDMODERETURNANGLEAUDIOSUB TITLE321 654 9870 /10ENTER+10DISPLAYMENUTOP MENUTV INTV CHTV CHVCR PWRPWRTVCALL-+-+--+MEMOBANDMODERETURNANGLEAUDIOSUB TITLE321 654 9870 /10ENTER+10DISPLAYMENUTOP MENUTV INTV CHTV CHVCR PWRPWRTVCALL• Point the remote control unit at the remote sensoron the main unit as shown on the diagram.• The remote control unit can be used from a straightdistance of approximately 7 meters/22 feet fromthe main unit, but this distance will be shorter ifthere are obstacles in the way or if the remotecontrol unit is not pointed directly at the remotesensor.• The remote control unit can be operated at ahorizontal angle of up to 30 degrees with respect tothe remote sensor.Approx. 7m / 22 feet30°30°q w eNOTES:• It may be difficult to operate the remote control unit if the remote sensor is exposed to direct sunlight orstrong artificial light.• Do not press buttons on the main unit and remote control unit simultaneously. Doing so may result inmalfunction.• Neon signs or other devices emitting pulse-type noise nearby may result in malfunction, so keep the set asfar away from such devices as possible.