Denon DHT-788BA Owner's Manual

Also see for AVR 788 - AV Receiver: Specifications Specifications Owner's manual Datasheet Compatibility guide

Contents

Denon DHT-788BA Owner's Manual Manual pdf 47 page image

ENGLISH1 Make the necessary preparations.q Set the iPod in the DENON Control Dock for iPod.(vSee the Control Dock for iPod’s operating instructions.)w Assign the Control Dock for iPod’s input.MENU : ”Input Setup” – “Assign” – ”iPod dock”(vpage 33)2 Either turn or press [iPod] toselect the input source assigned in step 1-w above.(iPod screen)b If the screens above are not displayed, the iPod may not beproperly connected. Try connecting again.3 Set [MODE SELECTOR 1] to “AUDIO” and [MODESELECTOR 2] to “iPod/NETWORK”.(vpage 48 “Remote Control Unit Operations”)Searching Categories1 Press o p.C A T : R o c k2 Use o p to select the category, then use ui to selectthe desired station.Channel categoryChecking the XM Signal Strength andRadio ID1 Either turn or press [SAT TU] toselect “XM”.2 Press STATUS until “SIGNAL” appears on thedisplay.The display will switch as shown below, depending on thereception conditions.Display StatusGOOD Signal strength is goodMARGINAL Signal strength is marginalWEAK Signal strength is weakNO No signal3 Adjust the position of the antenna until “SIGNAL:GOOD” is shown on the display.4 Press STATUS until the station you want to check(example: “XM001”) is displayed.5 Press TUNING and select channel 0 (XM000).The radio ID is shown on the display.X M 0 0 0 R A D I O I DThe strength of both the XM satellite and terrestrial signals can bechecked at menu “Input Setup” – “Antenna Aiming” (vpage 34).Radio IDGetting Started Connections Setup Playback Remote Control Multi-Zone Information TroubleshootingiPod® PlaybackThe music on an iPod can be played by using the Control Dock foriPod (ASD-1R, sold separately).The operation can also be performed using the buttons on the mainunit or remote control unit while watching the menus.iPod is a trademark of Apple Inc., registered in the U.S.and other countries.b The iPod may only be used to copy or play contents that are notcopyrighted or contents for which copying or playback is legallypermitted for your private use as an individual. Be sure to complywith applicable copyright legislation.OK to disconnect.NOTE• Depending on the type of iPod and the software version, somefunctions may not operate.• DENON will accept no responsibility whatsoever for any loss of iPoddata.• With the default settings, the iPod can be used connected to the VCR(iPod) connector.• Use the RESTORER mode to expand the low and high frequencycomponents of compressed audio fi les and achieve a richer sound.The default setting is “Mode3”.• Press and set the AVR-788’s power to the standbymode before disconnecting the iPod. Also switch the input sourceto one to which the menu “iPod dock” is not assigned beforedisconnecting the iPod.Basic Operation