Denon DN-2700F Operating Instructions Manual

• The operation shown in Figure 20 can be com-bined with the Reloop function to play a certainsection of a track repeatedly as many times asdesired stretching out the song. (Figure 22)Reloop• The reloop function is activated by pressing theEXIT/RELOOP button again after exiting loopplayback using EXIT/RELOOP button as de-scribed above. The Reloop function resumes loopplayback from the A point (the LOOP LED is againlit solid).MEMORY Figure 23• The DN-2700F has the capability to store disc identification information and start/end point playback data in memory.• The memory function uses the currently loaded discs only. Discs can not be swapped during memory play.(1) Types of Memory Playback Data• Memory data must be entered and stored in advance before performing memory playback. There are two types ofdata:• Type 1 - play start data. Type 2 - play start and play end dataEach start/end point may consist of one of the following:• Track number only (i.e. Track 4)• Track number and time data (i.e. Track 4, 2 min, 5 sec).• Memory data can be entered using the number keys and the jog/shuttle controls.• Up to 99 steps of memory data can be stored. Each start or end point occupies one step, so Type 2 data occupies 2memory steps.Type 1 - Play Start Data only• Play Start data specifies a location on the disc at which playback will begin in memory play mode.• When memory playback is started using Play Start data only, playback stops at the end of the track.• The Play Start point can be a track number only or a track number and specific time.Type 2 - Play Start and End Data• Play End data may be combined with Play Start data to specify both starting and ending playback points for a discin memory play mode.• When memory playback is started using Play Start and End data, playback stops at the position specified by theend data.• The Play Start and End points can be track numbers only or track numbers and specific time.(2) Disc Identification• Disc identification infomation is automatically stored in each memory step along with the start/end point data.Therefore, each memory step may be applied only to the disc for which it is programmed.• When a disc which has memory data is loaded into the unit, it is automatically identified and the MEMORYi ndicator in the LCD display will blink.• A maximum of 16 discs can be identified. Each disc may be referenced in an number of memory steps, with anoverall limit of 99 memory steps.19