Denon DN-333XAB User Manual

Also see for DN-333XAB: User guide

Contents

6PRIORITYMIC 1PRIORITYCHIMEONALARMONSetupGetting Started:1. Connect any microphones to the mic inputs or line-level devices to the line inputs.2. Connect your speakers to the Speaker Out using a properly wired 4-pin Euroblockconnector and speaker wire.3. Make sure all Level knobs are set to “MIN”.4. Connect the included power cable from the power input to a power outlet; power onDN-333XAB.5. Adjust the individual channel Level knobs and the Speaker Level knob to get a strongsignal without distortion or “clipping”.6. Adjust the Speaker Treble and Speaker Bass knobs to further control the frequencies ofthe sound.Using a Euroblock Connector (see the side graphic):1. Twist the speaker wire to form a tight strand andinsert this into the appropriate port, (following theindication located above the pins on DN-333XAB)pushing the wire until it is secured inside.2. Attach the Euroblock connector to the input terminalon DN-333XAB.3. To disconnect a wire, use a small screwdriver topress in the spring above the insert port while pullingout the wire.Items not listed under Introduction > Box Contents are sold separately.Power Speaker BluetoothDeviceMicrophoneMIC 1PRIORITY