Denon DN-X1500 Operating Instructions Manual

Also see for DN-X1500: Operating instructions Brochure & specs Operating instructions Service manual

Contents

Denon DN-X1500 Operating Instructions Manual Manual pdf 2 page image

2CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (ORBACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TOQUALIFIED SERVICE PESONNEL.The lightning flash with arrowhead symbol, within an equilateral triangle, is intended toalert the user to the presence of uninsulated “dangerous voltage” within the product’senclosure that may be of sufficient magnitude to constitute a risk of electric shock topersons.The exclamation point within an equilateral triangle is intended to alert the user to thepresence of important operating and maintenance (servicing) instructions in the literatureaccompanying the appliance.WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THISAPPLIANCE TO RAIN OR MOISTURE.CAUTION :1. Handle the power supply cord carefullyDo not damage or deform the power supply cord. If itis damaged or deformed, it may cause electric shockor malfunction when used. When removing from walloutlet, be sure to remove by holding the plugattachment and not by pulling the cord.2. Do not open the top coverIn order to prevent electric shock, do not open the topcover.If problems occur, contact your DENON dealer.3. Do not place anything insideDo not place metal objects or spill liquid inside the DJmixer.Electric shock or malfunction may result.Please, record and retain the Model name and serialnumber of your set shown on the rating label.Model No. DN-X1500 Serial No.This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference,and (2) this device must accept any interferencereceived, including interference that may causeundesired operation.This Class B digital apparatus meets all requirementsof the Canadian Interference-Causing EquipmentRegulations.Cet appareil numérique de la classe B respecte toutesles exigences du Règlement sur le matériel brouilleurdu Canada.CAUTIONTO PREVENT ELECTRIC SHOCK, MATCHWIDE BLADE OF PLUG TO WIDE SLOT,FULLY INSERT.ATTENTIONPOUR ÉVITER LES CHOCS ÉLECTRIQUES,INTERODUIRE LA LAME LA PLUS LARGEDE LA FICHE DANS LA BORNECORRESPONDANTE DE LA PRISE ETPOUSSER JUSQU’ AU FOND.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENLABELS:SAFETY INSTRUCTIONS1. Read Instructions – All the safety and operating instructionsshould be read before the product is operated.2. Retain Instructions – The safety and operating instructionsshould be retained for future reference.3. Heed Warnings – All warnings on the product and in theoperating instructions should be adhered to.4. Follow Instructions – All operating and use instructionsshould be followed.5. Cleaning – Unplug this product from the wall outlet beforecleaning. Do not use liquid cleaners or aerosol cleaners.6. Attachments – Do not use attachments not recommendedby the product manufacturer as they may cause hazards.7. Water and Moisture – Do not use this product near water –for example, near a bath tub, wash bowl, kitchen sink, orlaundry tub; in a wet basement; or near a swimming pool;and the like.8. Accessories – Do not place this product on an unstable cart,stand, tripod, bracket, or table. The product may fall,causing serious injury to a child or adult, and seriousdamage to the product. Use only with a cart, stand, tripod,bracket, or table recommended by the manufacturer, orsold with the product. Any mounting of the product shouldfollow the manufacturer’s instructions, and should use amounting accessoryrecommended by themanufacturer.9. A product and cartcombination should bemoved with care. Quickstops, excessive force,and uneven surfaces maycause the product and cartcombination to overturn.10. Ventilation – Slots and openings in the cabinet are providedfor ventilation and to ensure reliable operation of theproduct and to protect it from overheating, and theseopenings must not be blocked or covered. The openingsshould never be blocked by placing the product on a bed,sofa, rug, or other similar surface. This product should notbe placed in a built-in installation such as a bookcase or rackunless proper ventilation is provided or the manufacturer’sinstructions have been adhered to.11. Power Sources – This product should be operated onlyfrom the type of power source indicated on the markinglabel. If you are not sure of the type of power supply toyour home, consult your product dealer or local powercompany. For products intended to operate from batterypower, or other sources, refer to the operating instructions.12. Grounding or Polarization – This product may be equippedwith a polarized alternating-current line plug (a plug havingone blade wider than the other). This plug will fit into thepower outlet only one way. This is a safety feature. If youare unable to insert the plug fully into the outlet, tryreversing the plug. If the plug should still fail to fit, contactyour electrician to replace your obsolete outlet. Do notdefeat the safety purpose of the polarized plug.13. Power-Cord Protection – Power-supply cords should berouted so that they are not likely to be walked on or pinchedby items placed upon or against them, paying particularattention to cords at plugs, convenience receptacles, andthe point where they exit from the product.15. Outdoor Antenna Grounding – If an outside antenna orcable system is connected to the product, be sure theantenna or cable system is grounded so as to provide someprotection against voltage surges and built-up staticcharges. Article 810 of the National Electrical Code,ANSI/NFPA 70, provides information with regard to propergrounding of the mast and supporting structure, groundingof the lead-in wire to an antenna discharge unit, size ofgrounding conductors, location of antenna-discharge unit,connection to grounding electrodes, and requirements forthe grounding electrode. See Figure A.16. Lightning – For added protection for this product during alightning storm, or when it is left unattended and unusedfor long periods of time, unplug it from the wall outlet anddisconnect the antenna or cable system. This will preventdamage to the product due to lightning and power-linesurges.17. Power Lines – An outside antenna system should not belocated in the vicinity of overhead power lines or otherelectric light or power circuits, or where it can fall into suchpower lines or circuits. When installing an outside antennasystem, extreme care should be taken to keep fromtouching such power lines or circuits as contact with themmight be fatal.18. Overloading – Do not overload wall outlets, extensioncords, or integral convenience receptacles as this can resultin a risk of fire or electric shock.19. Object and Liquid Entry – Never push objects of any kindinto this product through openings as they may touchdangerous voltage points or short-out parts that couldresult in a fire or electric shock. Never spill liquid of anykind on the product.20. Servicing – Do not attempt to service this product yourselfas opening or removing covers may expose you todangerous voltage or other hazards. Refer all servicing toqualified service personnel.21. Damage Requiring Service – Unplug this product from thewall outlet and refer servicing to qualified service personnelunder the following conditions:a) When the power-supply cord or plug is damaged,b) If liquid has been spilled, or objects have fallen into theproduct,c) If the product has been exposed to rain or water,d) If the product does not operate normally by followingthe operating instructions. Adjust only those controlsthat are covered by the operating instructions as animproper adjustment of other controls may result indamage and will often require extensive work by aqualified technician to restore the product to its normaloperation,e) If the product has been dropped or damaged in any way,andf) When the product exhibits a distinct change inperformance – this indicates a need for service.22. Replacement Parts – When replacement parts are required,be sure the service technician has used replacement partsspecified by the manufacturer or have the samecharacteristics as the original part. Unauthorizedsubstitutions may result in fire, electric shock, or otherhazards.23. Safety Check – Upon completion of any service or repairsto this product, ask the service technician to perform safetychecks to determine that the product is in proper operatingcondition.24. Wall or Ceiling Mounting – The product should be mountedto a wall or ceiling only as recommended by themanufacturer.25. Heat – The product should be situated away from heatsources such as radiators, heat registers, stoves, or otherproducts (including amplifiers) that produce heat.FIGURE AEXAMPLE OF ANTENNA GROUNDINGAS PER NATIONALELECTRICAL CODE ANTENNALEAD INWIREGROUNDCLAMPELECTRICSERVICEEQUIPMENTANTENNADISCHARGE UNIT(NEC SECTION 810-20)GROUNDING CONDUCTORS(NEC SECTION 810-21)GROUND CLAMPSPOWER SERVICE GROUNDINGELECTRODE SYSTEM(NEC ART 250, PART H)NEC - NATIONAL ELECTRICAL CODE