Denon DNP-720AE Owner's Manual

Also see for DNP-720AE: Specification Owner's manual Owner's manual Service manual Network Setup Guide

Denon DNP-720AE Owner's Manual Manual pdf 28 page image

24ENGLISHConnecting wireless LANUse this procedure to configure the wireless LAN settings.n Search Access Point (Wireless LAN)1 Fitting a rod antenna (vpage 6 “Connecting toa home network (LAN)”).tIf a LAN cable is connected, remove it.2 Press ON/STANDBY to turn on power to the mainunit.3 Press [MENU].Turns on the menu settings mode and the menu appears onthe display (vpage 22 “Menu map”).4 Use ui to select “Network” – “Connection” –“Search Access Point”, then press [ENTER],<1/3 ENTER> or p.The access point you have set is displayed.5 Use ui to select the access point, and then press[ENTER], <1/3 ENTER> or p.tIf the access point is not detected automatically, configure itmanually (vpage 25 “Manual Settings”).6 If there is an encryption setting for the access pointyou selected in step 5, enter same encryption key asused for the access point. (If there is no encryptionsetting, proceed to step 7.)Use uio p to input the “Key” (encryption key) and press[ENTER], <1/3 ENTER> or p. Enter the same encryption keyas used for the access point.tThe types of characters that can be input are as shown below.GLower case charactersHabcdefghijklmnopqrstuvwxyzG Upper case charactersHABCDEFGHIJKLMNOPQRSTUVWXYZGSymbolsH ! “ # $ % & ‘ ( ) z + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ˜GNumbersH 0123456789 (Space)tWhen no security settings have been used in the Internetconnection settings, this step is not necessary.n Proxy settingsConfigure these settings to connect to the internet via a proxyserver.1 Press [MENU].Turns on the Menu settings mode and the Menu appears onthe display (vpage 22 “Menu map”).2 Use ui to select “Network” – “Connection” –“Proxy”, then press [ENTER], <1/3 ENTER> or p.“Setup Proxy” menu appears.3 If “Proxy(On)” appears, go to step 5.If “Proxy(Off)” appears, press [ENTER],<1/3 ENTER> or p.“Select Proxy” menu appears.4 Use ui to select “On”, then press [ENTER],<1/3 ENTER> or p.“Setup Proxy” menu appears.5 Use ui to select “Proxy (Address)” or “Proxy(Name)”, then press [ENTER], <1/3 ENTER> or p.“Select Type” menu appears.6 Use ui to select “Address” or “Name”, then press[ENTER], <1/3 ENTER> or p.“Setup Proxy” menu appears.7 Use ui to select “Address” or “Name”, then press[ENTER], <1/3 ENTER> or p.“Input Proxy Address” or “Input Proxy Name” menu appears.8 Use uip or [NUMBER] (0 – 9) to input the addressor name, then press [ENTER] or <1/3 ENTER>.“Setup Proxy” menu appears.9 Use ui to select “Port”, then press [ENTER],<1/3 ENTER> or p.“Input Proxy Port” menu appears.10 Use uip or [NUMBER] (0 – 9) to input the port,then press [ENTER] or <1/3 ENTER >.The Proxy settings are completed.Setting the network [Network]Button located on both the main unit and the remote controlBUTTONButton only on the main unit