|
ENGLISHGetting Started Connections Troubleshooting SpecificationsENGLISHRecording• The LINE3 input signal is not output to the recording output terminal(REC).• Adjusting the volume or tone does not affect the sound beingrecorded. • Noise may be produced in the sound when receiving AM broadcastsif there is e.g. a TV nearby. If so, move the DRA-CX3 and TV as farapart as possible.Tuning in radio broadcastsn FM station reception conditions• When the reception band mode is set to “FM AUTO”, the “ST”indicator lights when a stereo broadcast is tuned in.• If the signal is weak and the stereo broadcast reception is notstable, set the reception mode to “FM MONO”. The “MONO”indicator lights.n Auto tuningPress and hold in or [TUNING] to search for and tune in thenext stereo broadcast automatically.Stations cannot be tuned in if the signal is too weak.n Canceling auto tuningPress or [TUNING].n Manual tuningThe frequency changes one step at a time each time [TUNING] ispressed.Giving a name to the currently tuned in broadcaststation and presetting it• A total of 40 FM and AM broadcast stations combined can bepreset.• Preset stations can be given names of up to 8 characters.PresettingOperation1 Press FUNCTION to select the input function.CDTUNER LINE2LINE3PHONO LINE1 (iPod)>b The function can be switched directly to “TUNER” by pressing, to “CD” by pressing .The “iPod” indicator is displayed when a Control Dock for iPod isconnected. (“NO iPod” is displayed if no iPod is connected to theControl Dock for iPod.)2 Set the recorder to the recording mode.b For instructions on operating, see the operating instructions of theconnected component.3 Start playback on the player.b For instructions on operating, see the operating instructions of theconnected component.1 Press [TUNER] , or to select“TUNER”.• The reception frequency is displayed.2 Press [ BAND] to select the reception band.FM AUTO FM MONO AM3 Press [ TUNING] to select the reception frequency.• The “TUNED” indicator lights when a station is tuned in.1 Tune in the broadcast station.• The reception frequency is displayed.2 Press [EDIT].• The name input mode is set.3 Press [CHANNEL] to select the desired character.b Up to 8 characters can be input for each preset.The characters that can be input are as shown below.A B C D E F G H I J K L M N O P Q R S T U V W X Y Z0 7 ^ ’ ( ) * + , – . / = (space)b Press [TUNING] to move the cursor.b Press [CLEAR] to delete characters.4 Press [ENTER].• The name input mode is set.5 Press [CHANNEL] to select the preset number, thenpress [ENTER].• The reception frequency and reception mode are preset.• When in the pure direct mode, the tone is set to “flat” and thebalance to “center”. The tone and balance cannot be adjusted whenthis mode is selected.n To change the name of a preset station:q Call out the preset name to be changed, then press [EDIT].w Perform steps 3, 4 under “Giving a name to the currently tunedin broadcast station and presetting it”.n To only preset the station:q Press [ENTER] while the station is tuned in.w Perform step 5 under “Giving a name to the currently tuned inbroadcast station and presetting it”. PreviousNext |