3Introduction IntroductionENGLISHENGLISH●Before turning the power switch onCheck once again that all connections are correct and that thereare no problems with the connection cables.●Power is supplied to some of the circuitry even when the unit isset to the standby mode. When traveling or leaving home forlong periods of time, be sure to unplug the power cord from thepower outlet.●Sufficiently ventilate the place of installationIf the unit is left in a room full of the smoke from cigarettes, etc., forlong periods of time, the surface of the optical pickup could getdirty, in which case it will not be able to read the signals properly.●About condensationIf there is a major difference in temperature between the insideof the unit and the surroundings, condensation (dew) may formon the operating parts inside the unit, causing the unit not tooperate properly.If this happens, let the unit sit for an hour or two with the powerturned off and wait until there is little difference in temperaturebefore using the unit.●Cautions on using mobile phonesUsing a mobile phone near this unit may result in noise. If so,move the mobile phone away from this unit when it is in use.●Moving the unitTurn off the power and unplug the power cord from the poweroutlet.Next, disconnect the connection cables to other system unitsbefore moving the unit.●Note that the illustrations in these instructions may differ fromthe actual unit for explanation purposes.Moisture condensation may occur inside the unit when it ismoved from a cold place to a warm place, or after heating a coldroom or under conditions of high humidity. Do not use the unit atleast for 2 hours until its inside is dry.• Do not handle the AC cord with wet hands.• Do not pull on the AC cord when disconnecting it from AC walloutlet. Grasp it by the plug.• If, by accident, water is spilled on this unit, unplug the AC cordimmediately and take the unit to our authorised service centrefor servicing.Pay attention to the following before using this unit:●Moving the unit.To prevent short-circuits or damaged wires in the connectioncables, always unplug the power supply cord and disconnect theconnection cables between all other audio components whenmoving the unit.●Store the operating instructions in a safe place.After reading the operating instructions, store them in a safeplace as they could come in handy in the future.●Whenever is in the STANDBY state, the unitis still connected to AC line voltage.Please be sure to unplug the cord when you leave home for, say,a vacation.●Note that the illustrations in these instructions may differfrom the actual unit for explanation purposes.The serial number of this product may be found on the back ofthe unit. No others have the same serial number as yours. Youshould record the number and other vital information here andretain this book as a permanent record of your purchase to aididentification in case of theft.Cautions on HandlingDVD-2500BTBLU-RAY DISC PLAYERHDMIRESOLUTIONSD CARDON / STANDBY10 cm or moreWallDew WarningAvoid the Hazards of Electrical Shock and FireBefore UsingDate of PurchaseDealer Purchase fromDealer AddressDealer Phone No.Model No.Serial No.Supplied AccessoriesPlease check to make sure the following items are included withthe main unit in the carton.remote control (RC-1091) “R6P” (AA) batteries x2AC cord operating instructionsservice station listTrademark InformationHDMI, the HDMI logo and High-Definition Multimedia Interfaceare trademarks or registered trademarks of HDMI Licensing LLC.Manufactured under license from Dolby Laboratories. Dolby andthe double-D symbol are trademarks of Dolby Laboratories.Manufactured under license under U.S. Patent #’s: 5,451,942;5,956,674; 5,974,380; 5,978,762; 6,487,535 & other U.S. andworldwide patents issued & pending. “DTS” and “DTS DigitalSurround” are registered trademarks and the DTS logos andSymbol are trademarks of DTS, Inc. © 1996-2007 DTS, Inc. AllRights Reserved.E5J01_03_05ED_EN.book Page 3 Tuesday, November 11, 2008 11:38 AM