Denon DVD-2930 Service Manual

Also see for DVD-2930CI: Supplementary guide Operating instructions Specifications Specification Operating instructions

Contents

21DVD-2930/2930CIIn the accumulated laser on time display(Y : 1: CD, 2: DVD, nnnnn.n: Time [h])To check, select TB1 or TB2 using the SKIP REV and SKIP FWD buttons.In the color bar output setting (using the video encoder function)(Y : 1: Test pattern off2: Test pattern on3: Reserved (same as Y = 1)(1) When Y = 1 (test pattern off)Normal operation performed. SD Mode Register 3 (Address 0x44) bit 6 set to 0.(2) When Y = 2 (test pattern on)The video encoder test pattern is output, regardless of whether or not there is a disc.SD Mode Register 3 (Address 0x44) bit 6 set to 1.Output setting: Component/Interlace/480i output.(3) Y = 3 (Reserved) : Same as when Y = 1.In the monitor terminal setting(Y : 1: RF signal monitor setting (ANAMONI 1 and 2)2: Digital signal monitor setting (MONI 0 and 1)3: Digital signal monitor setting (MONI 2 and 3)4: Digital signal monitor setting (MONI 4 and5)5: Digital signal monitor setting (MONI 6 and 7)6: Remaining buffer capacity output setting (DRV2)ZZ : When Y = 1: 01 to 06, 09, 0AWhen Y = 2: 06 to 08, 0A, 0B, 0CWhen Y = 3: 06 to 08, 0A, 0B, 0CWhen Y = 4: 07 to 0FWhen Y = 5: 07 to 0F)4th place: During Y selection, " " displayed at 4th place.7th place: During ZZ selection, " " displayed at 7th place.When both Y and ZZ are set, " " displayed at 4th and 7th places.After selecting Y within the mode using the SKIP REV and SKIP FWD buttons, press the PLAY button once to set.Use the SKIP REV and SKIP FWD buttons to select ZZ within the mode.(When set at Y = 1, press the SKIP FWD button to switch in the order 01, 02, 03, 04, 05, 06, 09, 0A, 0C, 01 , then press thePLAY button once to set. If the SKIP REV and SKIP FWD buttons are pressed after setting, switches to Y within the mode.When Y = 1 is selected, the previously selected ZZ value is displayed.)The set values are not cleared even when the STOP button is pressed or when the STOP and SKIP FWD buttons are pressedsimultaneously.Remaining buffer capacity: PWM output of the remaining data capacity to the DRV2 terminal.(Notes: The remaining buffer capacity is the remaining data capacity, not the remaining free space. Also, the DRV2 terminal isalso used for tray driving, so when outputting the remaining buffer capacity, be careful not to drive the tray.)When Y = 2 or 3, if ZZ = 0C is selected, Dfesv (FE stored value) is output to the MONI 1 terminal, Tfesv (TE stored value) isoutput to the MONI 2 terminal and Dassv (AS stored value) is output to the MONI 3 terminal.2 2