!2 Inputs terminals (INPUTS)These are input terminals for CD players, turntables,AM/FM tuners, tape decks or other playback components.!3 Playing and recording input/output terminals(TAPE-1/CD-R, TAPE-2/MD)These are playing and recording input/output terminals forconnection to tape decks.!4 Power amp direct terminals(POWER AMP DIRECT)Souurce connected to this terminal is directly fed to thepower amp. set volume level by the component connectedto this terminal.!5 Power amp direct switch (POWER AMP DIRECT)ON position:Power amp direct terminal is selected when INPUTSELECTOR is set to AUX-2/P. DIRECT position.OFF position:AUX-2 is selected when INPUT SELECTOR is set to AUX-2/P. DIRECT position.6!6 Pre out terminals (PRE OUT)Use these when adding a power amplifier, a subwooferwith built-in power amplifier, etc.Connect these PRE OUT terminals to the input terminals onthe additional power amplifier, subwoofer, etc.!7 Speaker systems terminals(SPEAKER SYSTEMS)Connect the speaker systems here.!8 AC inlet receptacle (AC IN)Connect the included power supply cord here.Do not use any other cord than the provided power supplycord.!9 Attachment plug receptacles (AC OUTLETS)AC outlets are used for connecting amplifier componentunits, such as tuner, turntable, tape deck, etc.• SWITCHED (Total capacity: 120 W / 1 A):These outlets are turned ON/OFF when main powerswitch is turned on/off.• UNSWITCHED (Capacity: 240 W / 2 A):This outlet is always ON whether power switch is on oroff.NOTE:The PHONO input terminals are equipped with ashort pin-plug. Remove this plug to connect a recordplayer.Store the removed short pin-plug in a safe place so asnot to lose it.NOTE:Signals are outputted from the PRE OUT terminalseven when using headphones.No signal is outputted when selecting power ampdirect terminal (see o, page 5)Rear Panel!3!2 !5 !6!4 !7 !8!9@0@1NOTE:This equippment may be different according to thecountry.