Denon PMA-2010AE Owner's Manual

Also see for PMA-2010AE: Owner's manual

Contents

Connections Operation Troubleshooting SpecificationsIndexENGLISHFront Panelrewq t y i ouQ0Q1Q2Q3Part Names and FunctionsGetting Startedq Power indicatorChanges as shown below according to PMA-2010AE’s status.• For several seconds after the power is turnedon ··············································· Red (blinking)• Power “ON” ············································Green• Muting ······································· Red (blinking)• Standby······················································ Red• Power “OFF” ··············································· Offw Power switch(hON/STANDBY jOFF )When set to “hON/STANDBY”, the powerturns on, and when set to “jOFF”, the powerturns off.e Headphones jack (PHONES)• This jack is used to plug in the headphones.(The Speaker output is turned off when theheadphones are plugged.)• To prevent hearing loss, do not raise the volumelevel excessively when using headphones.r BASS control knobt TREBLE control knoby BALANCE control knobu VOLUME control knobi REC OUT SELECTOR knobo INPUT SELECTOR knobUse this to select the source that you wish tolisten to.Q0 Input indicatorThe selected input is shown with an orangeindicator.Q1 POWER AMP DIRECT switchBy switching this “hON”, it is possible to playback a device connected to the Power AmpDirect connector on the rear panel. In this case,the input indicator is turned off.By switching it “jOFF”, it is possible to playback the program source selected using theINPUT SELECTOR knob. In this case, the inputindicator lights up.NOTE• Functions r, t and y are only available whenthe SOURCE DIRECT switch is set to “jOFF”.• When the VOLUME control knob is set justbeyond the “12 o’clock” position (over halfway),the adjustments that can be made with the BASSand TREBLE controls is decreased.• When the VOLUME control knob is set tomaximum or turned fully clockwise, the base andtreble can no longer be adjusted.• When the POWER AMP DIRECT switch is“hON”, adjustment of the volume, balance andtone on the main unit has no effect. You shouldadjust the volume on the input device.• When the POWER AMP DIRECT switch is“hON”, the main unit is at its maximum volume.Check the output level on the input device beforeplayback, and adjust the volume accordingly.Q2 SOURCE DIRECT switchWhen set to “hON”, the signals do not passthrough the tone adjustment circuitry (bass,treble and balance), resulting in playback withhigher sound quality.When set to “jOFF”, the sound can beadjusted to your tastes.Q3 Remote control sensor1.PMA2010AEE2_ENG_006_2nd_0625.i3 3 2009/06/29 10:05:16