Getting Started Connections Setup Remote Control Information TroubleshootingENGLISHON/STANDBY<+/–><13>[ENTER][RETURN][DVD/CD],[FM/AM],[AUX], [iPod][TUNING +/–]1ON/STANDBY[DISPLAY][CHANNEL +/–][uio p] [ENTER][NUMBER][MEMO][uio p]About the button names in these explanations< > : Buttons on the main unit[ ] : Buttons on the remote control unitButton name only:Buttons on the main unit and remote control unitPlaybackTo only presetq Press [MEMO] while the broadcast station is tuned in.w Select the number using [ui], then press [ENTER].Or use [NUMBER] (0 ~ 9, +10) to select the number.NOTEIf a station is preset at a number that has already been preset, the oldsettings are deleted and replaced with the new settings.Automatically Presetting FM Stations(Auto preset)Up to 60 stations can be preset.1 Pressor[FM/AM]toselect“TUNER”.2 Pressandholdin<13>.“AUTO PRESET?” and “–NO/ +START” are displayedalternately.b Press <–> to cancel auto presetting.3 Press<+>.“SEARCH” flashes, then “COMPLETED” is displayed.• Broadcast stations whose antenna signal is weak cannot be presetautomatically. If you wish to preset such stations, tune them inmanually, then perform the operation at “Naming the currently tunedin broadcast station and presetting it”.• Once auto presetting starts, it cannot be canceled (it takes about 60seconds to be completed).Use<+/–>,[CHANNEL] or[NUMBER](0~9,+10)toselectthepresetnumber.b Operate <+/–> after switching to the preset mode (vpage 27).Listening to Preset StationsTo stop the auto tuningPress [TUNING +/–] or [o p].Manual tuningThe reception frequency changes each time [TUNING +/–] or [o p] ispressed.Naming the Currently Tuned in BroadcastStation and Presetting itUp to 60 stations (total for AM and FM) can be preset.Names of up to 8 characters can be input.1 Tuneinthebroadcaststation2 Press[MEMO] twice.The name input mode is set.3 Use [ui] to select the character, then press[ENTER].b Characters that can be input.A to Z, 0 to 9 + [CALL] for small letters! “ # $ % & ’ ( ) * + , – . / : ; < = > ? @ [ \ ] ˆ _ { ¦ } (space)b Press [op] to move the cursor.Use this to correct input characters.b To cancel character input, press [MEMO].Everything that has been input is canceled.4 Onceyouarefinishedinputting,press[ENTER].“P0 –” flashes on the preset number display.5 Use[ui]toselectthenumber,thenpress[ENTER].Oruse[NUMBER](0~9,+10)toselectthenumber.The preset number, reception band and reception frequency aredisplayed, then the name of the broadcast station appears.Changing the broadcast station nameq Call out the preset name you want to change, then press [MEMO]twice.wPerform steps 3 and 4 at “Naming the currently tuned in broadcaststation and presetting it”.