Denon SYS-391HT Owner's Manual

Contents

Denon SYS-391HT Owner's Manual Manual pdf 9 page image

3ENGLISH Getting started Connections Playback Troubleshooting Specifi cationsPart names and functionsRear panel (DSW-391)qwertq Line input connector (LINE IN)Connect this connector to the amplifier’s “SUBWOOFER PREOUT” connector using the included audio cable.w Volume adjustment control (LEVEL)Use this control to adjust the volume of the subwoofer.e Status indicatorThe two-colored light indicates the subwoofer’s operating status,as follows:• Power “ON” ··································Lights green• Standby mode·······························Lights red• Power “OFF” ·································Indicator offr Power operation switch (POWER ON/OFF)• Set this switch to “ON” to turn on power.• Set this switch to “OFF” to turn off power.t Power cordWhen connecting the speakers to an amplifier, be sure to read theamplifier’s owner’s manual carefully and connect properly.Speaker connections(SC-F391, SC-C391, SC-R391)• Connect the input terminals on the rear panel of the speaker withthe speaker output terminals on the amplifier, using the includedspeaker cables.• Labels on the back of each speaker are marked “FR”, “FL”, “C”, “SR”,“SL”. Connect each speaker to the following amplifier terminals. Besure to connect each speaker with correct polarity (+, –).• FR To the amplifier’s front-right speaker terminal.• FL To the amplifi er’s front-left speaker terminal• C To the amplifi er’s center speaker terminal• SR To the amplifier’s surround-right speaker terminal.• SL To the amplifier’s surround-left speaker terminal.Amplifiers have various speaker output terminals.Check the owner’s manual of the amplifier you are using for details.NOTE• Be sure to turn the amplifi er’s power off before connecting thespeakers to the amplifier.• If the polarities are inverted, the phase may be off and the soundmay have no bass component, making it seem unnatural. Be sureto connect the polarities properly.ConnectionsConnecting the speaker cablesBlack : “–” (negative) Red : “+” (positive)Black withwhite line cableLeverBlack cable1 Peel off the sheath from the tip ofthe speaker cable, then firmly twistthe wires by hand so that they do notstick out and cause short-circuits.2 Press and lower the lever, and insertthe cable’s core wire into the hole.3 Release the lever.Gently pull on the speaker cable tocheck that it is firmly connected.Once connections are completed, pull gently on the speaker cablesto check that they are securely connected.NOTEDo not let the core wires of two speaker cables touch each other.Doing so will short-circuit the amplifier circuitry and damage theamplifier.Getting started Connections