Denso BHT-200 Supported Equipment Manual

Contents

Denso BHT-200 Supported Equipment Manual Manual pdf 19 page image

Standard SetupStarting a Telnet SessionAt the Twin Client main menu on the terminal, press any key to establish the connection.Until the terminal has been authorized, the following screen is displayed.RECOVERABLE ERRORTerminal notAuthorized forTwin ClientKeypress to continue…It is not necessary to authorize the terminal at this time, so press any key to continue. Theterminal will establish a connection with the host system and start emulation.After a Telnet session has been successfully established, the terminal will remain insession for a maximum of 30 minutes at a time until it has been authorized. Onceauthorized, there is no software restriction to the session time. The instructions forauthorizing the terminal are presented in Authorizing PowerNet.Standard SetupThe default terminal setup is sufficient for most installations. However, to meet site-specific requirements, it may be necessary to customize terminal operation. The standardsetup options simplify this process and can be modified by the following methods:• Using the Twin Client Manager.• Using the Twin Client terminal menu system.This section describes how to use the Twin Client Manager and the terminal menu systemto set up the terminal. Also described are the methods for authorizing the terminalsoftware.Setup Using Twin Client ManagerThe Twin Client Manager provides a Standard Settings tab for automatic setup of theterminals. The options within this tab vary according to the emulation selected, each ofwhich is described below. Click on Standard under the View option in the main menu.VT SettingsSelect the VT emulation setup by clicking on the Settings menu and then the Emulationmenu, as shown below.Supported Equipment Manual• May, 2006 2-13