Denver Instrument MAXX Operating Instructions Manual

Contents

Denver Instrument MAXX Operating Instructions Manual Manual pdf 17 page image

17Most error codes are shown on the main display for approx. 2 seconds.The program then returns automatically to the previous mode.Display/Problem Cause SolutionNo segments appear No power available Check the power supplyon the displayThe AC adapter is not plugged in Plug in the AC adapterBattery is drained Replace battery; rechargebattery using externalchargeroL The load exceeds the Unload the balance/scalebalance/scale capacityUL Weighing pan not in place Place the weighing panon the balance/scaleSomething is touching Move the object that isthe weighing pan touching the weighing pandisErr Display overflow: Reduce load on theValue cannot be shown balance/scaleon the displaycalErr Calibration parameter not met; e.g.: Calibrate only when zerois displayed– Balance/scale not zeroed Press (ZERO) to tare thebalance/scale– Balance/scale is loaded Unload the balance/scaleappErr Weight is too light or there is Increase the weightno sample on the balance/scale on the balance/scalewith application in usePrtErr Data interface for Contact the Denverprinting is blocked customer service centerBal.Err Balance/scale loaded or defective Unload balance/scale beforewhen power was turned on switching on or contactDenver customer service*Sep.Err Balance/scale defective Contact Denver customerserviceMax. weighing capacity The balance/scale was Place the weighing panis less than indicated switched on without on the balance/scale andunder “Specifications” the weighing pan in place press (ON/OFF)The weight readout The balance/scale was not Calibrate/adjust theis obviously wrong calibrated/adjusted before weighing balance/scaleBalance/scale not zeroed Zero the balance/scaleIf any other errors occur, contact your local Denver customer service center* This fault will appear on the display when the unit is powered on. This occurs when the electronics are no longerwithin the factory set parameters. The most common cause is from objects being dropped onto the weighing pan orfrom the balance itself being dropped. The balance must be returned for service.Error Codes

/ 20

Related manuals for Denver Instrument MAXX