Desa 30 Owner's Manual

Also see for 0: Owner's manual Owner's manual OWNER'S OPERATION AND INSTALLATION MANUAL Owner's manual Owner's manual

Desa 30 Owner's Manual Manual pdf 5 page image

5099606UNPACKING 1. Remove all packing items applied to heater for shipment.2. Remove all items from carton.3. Check items for any shipping damage. If heater is damaged, promptly informdealer where you bought heater.ASSEMBLY(For 90,000 and 150,000BTU/Hr Models Only)These models are furnished with wheels and handles. Wheels, handles, and themounting hardware are found in the shipping carton.Tools Needed• Medium Phillips Screwdriver• 3/8" Open or Adjustable Wrench• Hammer1. Slide axle through wheel support frame. Install wheels on axle.IMPORTANT: When installing wheels, point extended hub of wheels towardwheel support frame (see Figure 4).2. Place cap nuts on axle ends. Gently tap with hammer to secure.3. Place heater on wheel support frame. Make sure air inlet end (rear) of heater isover wheels. Line up holes on fuel tank flange with holes on wheel supportframe.4. Place front handle and rear handle on top of fuel tank flange. Insert screwsthrough handles, fuel tank flange, and wheel support frame. Attach nut fingertight after each screw is inserted.5. After all screws are inserted, tighten nuts firmly.ASSEMBLY, EURO PFA/PV 018AFigure 4 - Wheel and Handle Assembly, 90/150,000 BTU/Hr Models OnlyScrewFuelTankFlangeWheelSupportFrameWheelCap NutNutAxleExtendedHubAirInletRearHandleFrontHandleHot AirOutlet