Desa AMITY SDVBPD Owner's Operation And Installation Manual

Also see for Amity PSCIVFC Series: OWNER'S OPERATION AND INSTALLATION MANUAL

112126-01BFor more information, visit www.desatech.comFor more information, visit www.desatech.com66. Remove all contents from inside stove cavity. Contents include:(1) - Stove bottom [Amity Only] (Discard - Not used withthis application)(4) - Legs with leg leveler bolts(1) - Bottom door(3) - Top grates(1) - Hardware kit bag with fasteners7. Carefully lay stove body on back to attach bottom components tostove body (see Figure 7). Rest stove on drop cloth or blanket toavoid scratching stove edges.8. Remove remaining pallet wood attached to bottom of stovebody (see Figure 8). Use an adjustable wrench to remove bolts.9. Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts.Use a flat washer and lock washer with each bolt. Tighten boltsinto threaded holes on stove body (see Figures 9 and 10). Usean adjustable wrench or a 12mm and 6mm socket.10. Attach stove door by inserting step bolt through door hinge pivothole and into threaded hole in stove body (Figures 9 and 11). Usean adjustable wrench or a 12mm socket to fasten step bolt. Tightenstep bolt until snug. Make sure door moves freely.Figure 10 - Attaching Stove Legs (Oxford™ Model Shown)Bottom OfStove UnitLegBoltWashersCAST IRON STOVE ANDDIRECT-VENT BURNERSYSTEM ASSEMBLYContinuedFigure 7 - Laying Down Stove On SideFigure 8 - Removing Pallet Wood From The Bottom of The StovePalletWoodBoltPalletWoodBottom OfStove UnitFrontPalletWoodBolted toBottom ofStove BodyFront ofStoveUnitTop of Stove UnitFront ofStove UnitTop ofStoveUnitDropCloth/BlanketFigure 9 - Locating Threaded Holes for Legs and Door AttachmentDoor Hinge StepBolt HoleDoor Catch BoltWith AdjustableHex Nuts HoleLeg HoleFrontBottom ofStove UnitCAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLYStove Body Assembly (Cont.)11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts)into threaded hole on stove body (see Figure 9). Use an adjust-able wrench or a 12mm socket. The catch bolt has two hex nutsattached to it (see Figure 12). The top nut is a bolt stop and thebottom nut is for door leveling adjustment.Figure 11 - Attaching Stove DoorStepBoltDoor HingeThreadedHoleStove DoorBolt ShoulderAdjustingNutBolt StopCatchBoltDoor ClawDoorFigure 12 - Catch Bolt andDoor Claw Orientation