Desa Air Conditioner Owner's Manual

Also see for 125-F: Service manual

Contents

Desa Air Conditioner Owner's Manual Manual pdf 5 page image

www.desatech.com113893-01B 51. Provide propane supply system (see PropaneSupply, page 4).2. Connect fuel gas connector fitting onhose/regulator assembly to propane tank(s).Turn counterclockwise into threads ontank valve. Tighten firmly using wrench.IMPORTANT: Tighten regulator with ventpointing down. Pointing vent down protectsregulator from weather damage.3. Connect hose to inlet connector. Tightenfirmly using a wrench. IMPORTANT: Extrahose or piping may be used if needed. Installextra hose or piping between hose/regulatorassembly and propane tank. You must use theregulator supplied with heater.4. Open propane supply valve on propane tank(s)slowly. Note: If not opened slowly, excess-flow check valve on propane tank may stopgas flow. If this happens, close propane supplyvalve and open again slowly.5. Check all connections for leaks.6. Close propane supply valve.INSTALLATIONContinuedFigure 4 - Hose and Inlet Connector(Heater may vary from illustration)Hose Inlet ConnectorFigure 3 - Regulator With Vent PointingDownPropaneTankHoseRegulatorVent(pointingdown)Fuel GasConnectorSupplyValveVENTILATIONWARNING: Follow the mini-mum fresh, outside air ventila-tion requirements. If properfresh, outside air ventilation isnot provided, carbon monoxidepoisoning can occur. Provideproper fresh, outside air ventila-tion before running heater.Provide a fresh air opening of at least three squarefeet for each 100,000 Btu/Hr (105,500 k/j) rat-ing. Provide extra fresh air if more heaters arebeing used.OPERATIONWARNING: Review and un-derstand the warnings in theSafety Information section, page2. They are needed to safely op-erate this heater. Follow all localcodes when using this heater.TO START HEATER1. Follow all installation, ventilation and safetyinformation.2. Locate heater on stable and level surface.Make sure strong drafts do not blow into frontor rear of heater.3. Plug power cord of heater into a three-prong,grounded extension cord. Extension cord mustbe at least six feet (1.83 m) long, UL/CSAlisted and of a proper size.Extension Cord Size RequirementUp to 100 feet (30.5 m) long, use 16 AWGrated cord.101 to 200 feet (30.78 to 61 m) long, use 14AWG rated cord.4. Plug extension cord into a 120 volt/60 hertz,three-hole, grounded outlet. Motor will start.Fan will turn, forcing air out front of heater.5. Open propane supply valve on propanetank(s) slowly. Note: If not opened slowly,excess-flow check valve on propane tank willstop gas flow. You may hear a click from theexcess-flow check valve closing. If this hap-pens, reset the excess-flow check valve byclosing propane supply valve and open againslowly.