Desa CDCFNR Owner's Operation And Installation Manual

Also see for CDCFNR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operation

Contents

www.desatech.com 111244-01D16Installation must include an equipment shutoffvalve, union, and plugged 1/8" NPT tap. LocateNPT tap within reach for test gauge hook up. NPTtap must be upstream from heater (see Figure 21).IMPORTANT: Install equipment shutoff valvein an accessible location. The equipment shutoffvalve is for turning on or shutting off the gas tothe appliance.Check your building codes for any special re-quirements for locating equipment shutoff valveto fireplaces.Apply pipe joint sealant lightly to male NPTthreads. This will prevent excess sealant fromgoing into pipe. Excess sealant in pipe could resultin clogged fireplace valves.WARNING: Use pipe jointsealant that is resistant to liquidpetroleum (LP) gas.INSTALLATIONContinued* Purchase the optional CSA design-certifiedequipment shutoff valve from your dealer. SeeAccessories, page 44.Figure 21 - Gas ConnectionCSA Design-CertifiedEquipment Shutoff ValveWith 1/8" NPT Tap*3" MinimumApprovedFlexibleGas LinePipe Nipple Cap Tee JointPROPANE/LPFrom ExternalRegulator (11"W.C.**to 14" W.C.Pressure)NATURALFrom Gas Meter(5" W.C.** to10.5" W.C.Pressure)Sediment TrapPropane/LPSupplyTank ExternalRegulatorFigure 20 - External Regulator With VentPointing DownVentPointingDownCONNECTING TO GAS SUPPLYWARNING: This appliancerequires a 45° male flare fitting5/8"-18 UNF (Unified National FineThread) inlet connection and theflexible gas line provided.WARNING: A qualified serviceperson must connect fireplace togas supply. Follow all local codes.WARNING: Never connect natu-ral gas fireplace to private (non-util-ity) gas wells. This gas is commonlyknown as wellhead gas.IMPORTANT: For natural gas, check gas linepressure before connecting fireplace to gas line.Gas line pressure must be no greater than 14 inchesof water. If gas line pressure is higher, heaterregulator damage could occur.CAUTION: Never connect pro-pane/LP fireplace directly to thepropane/LP supply. This fireplacerequires an external regulator(not supplied). Install the externalregulator between the fireplaceand propane/LP supply.For propane/LP units, the installer must supplyan external regulator. The external regulator willreduce incoming gas pressure. You must reduceincoming gas pressure to between 11 and 14inches of water. If you do not reduce incoming gaspressure, fireplace regulator damage could occur.Install external regulator with the vent pointingdown as shown in Figure 20. Pointing the ventdown protects it from freezing rain or sleet.CAUTION: Use only new, blackiron or steel pipe. Internally-tinnedcopper tubing may be used in cer-tain areas. Check your local codes.Use pipe of 1/2" or greater diameterto allow proper gas volume to fire-place. If pipe is too small, undueloss of volume will occur.