Desa CDCFPR Owner's Operation And Installation Manual

Also see for CDCFNR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operation

Contents

www.desatech.com111244-01F 5OPTIONAL REMOTECONTROL ACCESSORIES(For Remote-Ready Models Only)There are four optional remote controls thatcan be purchased separately for Remote-ReadyModels only:• wall switch • hand-held ON/OFF remote• wall thermostat • hand-held thermostat remoteSee Accessories, page 44.LOCAL CODESInstall and use fireplace with care. Follow all localcodes. In the absence of local codes, use the lat-est edition of The National Fuel Gas Code ANSIZ223.1/NFPA 54*.*Available from:American National Standards Institute, Inc.1430 BroadwayNew York, NY 10018National Fire Protection Association, Inc.Batterymarch ParkQuincy, MA 02269PRODUCT FEATURESSAFETY PILOTThis fireplace has a pilot with an Oxygen Deple-tion Sensing (ODS) safety shutoff system. TheODS/pilot is a required feature for vent-free roomfireplaces. The ODS/pilot shuts off the fireplace ifthere is not enough fresh air.PIEZO IGNITION SYSTEMThis fireplace has a piezo ignitor. This systemrequires no matches, batteries, or other sourcesto light fireplace.THERMOSTATIC HEAT CONTROLFOR THERMOSTAT-CONTROLLEDMODELSThermostat-Controlled models have a thermostatsensing bulb and a control valve. The thermostatwill automatically modulate the heat output tomaintain a consistent room temperature. Thisresults in greater fireplace comfort. This can alsoresult in lower gas bills.UNPACKINGWARNING: Ceramic brickliners for Models CDCFNR andCDCFPR are located behind up-per louver and must be removedbefore lighting fireplace.1. Remove fireplace and hood from carton.Log is wrapped and inside fireplace. Do notremove at this time.2. Remove all protective packaging applied tofireplace for shipment.3. Make sure your fireplace includes one hard-ware packet.4. Check fireplace for any shipping damage. Iffireplace is damaged, promptly inform dealerwhere you bought fireplace.Models CDCFNR/PR only1. Remove screws from top louver and carefullyremove louver (see Figure 2).2. Remove ceramic brick liners with protectivepackaging. The brick liners will be installedlater.3. Remove yellow sticker from top of firebox.4. Replace top louver using screws removed instep 1.Figure 2 - Removing Brick Liners FromCDCFNR/PRTop LouverScrewsWrappedBrick Liners