Desa CFS18NRA Owner's Operation And Installation Manual

Contents

Desa CFS18NRA Owner's Operation And Installation Manual Manual pdf 3 page image

3104416OWNER’S MANUALAUTOMANOFFSTATUSONLOHITEMPPRODUCTIDENTIFICATIONFigure 1 - VS24NR ShownLOCAL CODESInstall and use heater with care. Follow alllocal codes. In the absence of local codes, usethe latest edition of The National Fuel GasCode ANS Z223.1, also known as NFPA 54*.*Available from:American National Standards Institute, Inc.1430 BroadwayNew York, NY 10018National Fire Protection Association, Inc.Batterymarch ParkQuincy, MA 02269Note: Where listed vented decorative logsare required, thermostat operation is notpermitted.UNPACKINGPRODUCTFEATURESOPERATIONThis heater is clean burning. It requires nooutside venting. There is no heat loss out avent or up a chimney. Heat is generated byboth realistic flames and glowing coals.This heater is designed for vent-free opera-tion with flue damper closed. It has beentested and approved to ANS Z21.11.2 stan-dard for unvented heaters. State and localcodes in some areas prohibit the use of vent-free heaters. This heater may also be oper-ated as a vented decorative (ANS Z21.60)product by opening the flue damper (non-thermostat operation only).SAFETY PILOTThis heater has a pilot with an OxygenDetection Safety Pilot System (ODS). TheODS/pilot is a required feature for vent-freeroom heaters. The ODS/pilot shuts off theheater if there is not enough fresh air.PIEZO IGNITION SYSTEMThis heater has a piezo ignitor. This systemrequires no matches, batteries, or othersources to light heater.Control KnobRear LogBaseAssemblyFrontBurnerPiezoIgnitorRearBurnerCrossover LogMiddleLogFront LogSelectorSwitch(Optional)FlameAdjustmentKnobRemoteControl(Optional)OPTIONALREMOTE CONTROLACCESSORIESThere are four optional remote controls thatcan be purchased separately for this logheater:• wall switch• wall thermostat• hand-held ON/OFF remote• hand-held thermostat remote.See Accessories, page 25.The wall thermostat or hand-held thermo-stat may not be used where vented decora-tive listing is required.CAUTION: Do not remove themetal data plates attached to theheater base assembly. The dataplates contain important warrantyinformation.1. Remove logs and heater base assem-bly from carton.Note: Do not pick upheater base assembly by burners. Thiscould damage heater. Always handlebase assembly by grate.2. Remove all protective packaging ap-plied to logs and heater for shipment.3. Check all items for any shipping dam-age. If damaged, promptly informdealer where you bought heater.