Desa CGEFP33PR Owner's Operation And Installation Manual

Also see for Comfort Glow CGEFP33NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

108117For more information, visit www.desatech.comFor more information, visit www.desatech.com2121INSTALLATIONAssembling And Attaching Optional Brass Trim (Cont.)Installing HoodInstalling Logs (VTGF33NR/VTGF33PR)INSTALLATIONContinuedFigure 39 - Attaching Brass Trim to Fireplace (EFP33PR Shown)TrimHangingScrewsAssembledBrass TrimHangingNotcheson TrimFigure 38 - Assembling Brass TrimSlotMitered EdgeSlotShimSet ScrewsAdjustingPlateSide BrassTrimFigure 40 - Installing Hood to Firebox (EFP33PR Shown)INSTALLING HOODInstall hood to top of firebox as shown in Figure 40. Use 3 Phillipsscrews provided.WARNING: Failure to position the parts in accor-dance with these diagrams or failure to use only partsspecifically approved with this heater may result inproperty damage or personal injury.CAUTION: Do not remove the warning and in-struction labels attached to the heater base assem-bly. These markings contain important warranty in-formation.CAUTION: After installation and periodically there-after, check to ensure that no flame comes in contactwith any log. With the heater set to High, check to seeif flames contact any log. If so, reposition logs ac-cording to the log installation instructions in thismanual. Flames contacting logs will create soot.INSTALLING LOGS (VTGF33NR/VTGF33PR)Each log is marked with a number. These numbers will help youidentify the log when installing. It is very important to install theselogs exactly as instructed. Do not modify logs. Only use logssupplied with heater.1. Place front logs (#1a and #1b) on top of the grate. Make surethe notches in the bottom of the log fit over the grate prongs(see Figure 41). Push back of log flush with metal grate bar.2. Rest middle log (#2) behind metal posts on front burner. Makesure the grooves in the bottom of the log fit over the grate.Bring the log forward next to the metal posts (see Figure 42).3. Slide the grooves in the back of the rear log (#3) against therear grate prongs. Make sure the peg on the log is on top (seeFigure 43, page 22).4. Place the crossover log (#4) on the rear log and the middle log.Make sure the peg on the rear log is in the hole in the bottomof the crossover log. The crossover log should fit in the cutoutof the middle log (see Figure 44, page 22).Figure 41 - Installing FrontLogs (#1a and #1b)Top BrassTrimFront Log(#1b)GrateProngsNotchMetalGrate BarFront Log (#1a)Figure 42 - Installing MiddleLog (#2)Middle Log (#2)Metal PostGrooveGrooveGrateMetalPost