Desa CGEFP33PRA Owner's Operation And Installation Manual

Contents

110149-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com24INSTALLING BATTERY INTO REMOTE1. Locate slot at bottom of remote control (see Figure 53). Firmlyinsert tool such as a small screwdriver, butter knife, or dimeinto the slot and lift up to remove cover.2. Insert supplied battery into remote control. Positive and nega-tive are marked inside remote control casing.Note: Remotewill not function if battery is not installed correctly.3. Slide tab on cover into remote housing and snap cover backinto place.IMPORTANT: Use only A23 12 volt battery in remote. DO NOTuse AAA battery.PositiveFigure 53 - Installing BatteryNegativeTabCoverRemoteControlSlotINSTALLATIONInstalling Battery Into RemoteInstalling ScreenOPERATING FIREPLACEFor Your Safety Read Before LightingINSTALLATIONContinuedA23 12VoltBatteryFigure 54 - Installing Fireplace Screen (EFP33PRA Shown)INSTALLING SCREENInstall fireplace screen by slipping notches of fireplace screen overscrews on front of fireplace (see Figure 54).NotchesScrews forMounting ScreenOPERATING FIREPLACEFOR YOUR SAFETY READBEFORE LIGHTINGWARNING: If you do not follow these instructionsexactly, a fire or explosion may result causing prop-erty damage, personal injury or loss of life.A. This appliance has a pilot which lights automatically whenusing the supplied wall switch or remote control. If youhave a power outage, the pilot may be lighted by hand withpush-button piezo ignitor. When lighting the pilot, the fol-lowing warnings must be followed.B. BEFORE LIGHTING smell all around the appliance areafor gas. Be sure to smell next to the floor because some gasis heavier than air and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; do not use any phone inyour building.• Immediately call your gas supplier from a neighbor’sphone. Follow the gas supplier’s instructions.• If you cannot reach your gas supplier, call the fire de-partment.C. Electric Power Outage Only: Use only your hand to turnthe manual override handle on the gas control knob. Neveruse tools. If the knob will not turn by hand, don’t try torepair it, call a qualified service technician or gas supplier.Force or attempted repair may result in a fire or explosion.D. Do not use this appliance if any part has been under water.Immediately call a qualified service technician to inspectthe appliance and to replace any part of the control systemand any gas control which has been under water.