Desa CGP20B Owner's Operation And Installation Manual

Also see for CGP20B: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa CGP20B Owner's Operation And Installation Manual Manual pdf 12 page image

12104412VENT-FREE PROPANE/LP GAS HEATERBLUE-FLAMETO TURN OFF GASTO APPLIANCEShutting Off Heater1. Turn control knob clockwiseto the PILOT position.2. Press in control knob and turn clock-wise to the OFF position.3. Turn off all electric power to the ap-pliance if service is to be performed.Shutting Off Burner Only (pilotstays lit)Turn control knob clockwise tothe PILOT position.MANUAL LIGHTINGPROCEDURE1. Remove front panel (see Figure 6,page 8).2. Follow steps 1 through 5 under Light-ing Instructions.3. With control knob pressed in, strikematch. Hold match to pilot until pi-lot lights.4. Keep control knob pressed in for 30seconds after lighting pilot. After 30seconds, release control knob. Now fol-low step 8 under Lighting Instructions.5. Replace front panel.LIGHTINGINSTRUCTIONSOPERATINGHEATERContinuedCAUTION: Do not try to ad-just heating levels by using theequipment shutoff valve.1. STOP! Read the safety informationon page 11, column 3.2. Make sure equipment shutoff valveis fully open.3. Turn control knob clockwiseto the OFF position.4. Wait five (5) minutes to clear out anygas. Then smell for gas including nearthe floor. If you smell gas, STOP! Fol-low “B” in the safety information onpage 11, column 3. If you don’t smellgas, go to the next step.5. Press in control knob and turn coun-terclockwise to the PILOTposition. Keep control knob pressedin for five (5) seconds (see Figure 16).Note: You may be running thisheater for the first time after hook-ing up to gas supply. If so, the con-trol knob may need to be pressed infor 30 seconds. This will allow air tobleed from the gas system.• If control knob does not pop upwhen released, contact a qualifiedservice person or gas supplier forrepairs.6. With control knob pressed in, pushdown and release ignitor button. Thiswill light pilot. The pilot is attachedto the front of burner. The burnerand pilot are located behind the heatshield. If needed, keep pressing igni-tor button until pilot lights.Note: If pilot does not stay lit, referto Troubleshooting, pages 14 through16. Also contact a qualified serviceperson or gas supplier for repairs.Until repairs are made, light pilotwith match. To light pilot with match,see Manual Lighting Procedure.7. Keep control knob pressed in for 30seconds after lighting pilot. After 30seconds, release control knob.Note: If pilot goes out, repeat steps3 through 7.8. Turn control knob counterclockwiseto the LOW position. Themain burner should light. Set controlknob to any heat level between HIGHand LOW. To turn control knob fromLOW to a higher setting, press in thecontrol knob and turn counterclock-wise .Note: Both HIGH and LOW arelocked positions. You must press incontrol knob before turning it fromthese positions.Figure 16 - Control Knob In The OFFPositionOFFHIGHPILOTLOWIGNITORIgnitor Button Control KnobFigure 17 - PilotThermocouplePilot BurnerIgnitor Electrode