Desa CSG3930PR Owner's Operation And Installation Manual

Also see for CSG3924NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operating & installation manual Owner's manual

Desa CSG3930PR Owner's Operation And Installation Manual Manual pdf 20 page image

110021-01GFor more information, visit www.desatech.comFor more information, visit www.desatech.com20Figure 34 - Control Knobs, Selector Switch and Ignitor ButtonLocations for Hand-Held Remote OperationFigure 32 - Pilot (Propane/LP)Ignitor ElectrodePilot BurnerThermocoupleFigure 33 - Pilot (Natural)IgnitorElectrodePilot BurnerThermocoupleShutting Off Heater1. Turn control knob clockwise to the OFF position.2. Turn rear burner control knob clockwise to theOFF position.3a. Set selector switch in the OFF position.3b. If Using Optional Hand-Held Remote: Set selector switchin the OFF position to prevent draining battery.1. Follow steps 1 through 6 under Lighting Instructions, page 20.2. Depress control knob and light pilot with match.3. Keep control knob pressed in for 30 seconds after lightingpilot. After 30 seconds, release control knob. Now follow steps9 through 11, Lighting Instructions, page 19 and column 1.CAUTION: Do not try to adjust heating levels byusing the equipment shutoff valve.WARNING: Make sure the selector switch is in theOFF position when you are away from home for longperiods of time. Heater will come on automaticallywith selector switch in the ON position.OPERATING HEATERContinuedOFFPILOTONAUTOOFFONFigure 31 - Control Knobs and Ignitor Button Locations (Shownas Supplied, No Remote Control Operation)Rear BurnerControl KnobSelectorSwitchIgnitor ButtonControl KnobOPERATING HEATER (REMOTE-READY MODELS)Lighting Instructions (Cont.)To Turn Off Gas To ApplianceManual Lighting ProcedureOptional Remote OperationTO TURN OFF GASTO APPLIANCEMANUAL LIGHTINGPROCEDUREOPTIONAL HAND-HELDREMOTE OPERATIONNOTICE: You must light the pilot before using thehand-held remote control unit. SeeLighting Instruc-tions, page 19.1. After lighting, let pilot flame burn for about one minute.Turn control knob to ON position. Adjust flame adjustmentknob anywhere between HI and LO. Slide the selector switchto the REMOTE position (see Figure 34).Note: The burnermay light if hand-held remote was on when selector switchwas last turned off. You can now turn the burner on and offwith the hand-held remote control unit.IMPORTANT: Do not leave the selector switch in the RE-MOTE or ON position when the pilot is not lit. This willdrain the battery.OFFPILOTONAUTOOFFONRear BurnerControl KnobSelectorSwitch Ignitor ButtonControl Knob11. To light the front/rear burners, push in and turn rear burnercontrol knob counterclockwise to the ON position.Shutting Off Burners Only (pilot stays lit)You may shut off the burners and keep the pilot lit by doing oneof the following:1. Turn control knob clockwise to the PILOT position.2. Turn rear burner control knob clockwise to theOFF position.3. Use remote control manual OFF button.4. Set selector switch in the OFF position.Note: All remote control accessories must be purchased sepa-rately (see Accessories, pages 38 and 39). Follow instructionsincluded with the remote control.