Desa Comfort Glow CGP10R Owner's Operation And Installation Manual

Also see for Comfort Glow CGP10R: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa Comfort Glow CGP10R Owner's Operation And Installation Manual Manual pdf 10 page image

10103548GAS RESIDENTIAL HEATERSOFFPILOTIGNITORLOWHIGHTO SELECTHEATING LEVEL1. Slightly press in control knob andturn counterclockwise o theLOW or HIGH positions.IMPORTANT: Release downwardpressure while turning control knob.Control knob will lock at the desiredposition.Pilot BurnerThermocoupleFigure 17 - Pilot7. Keep control knob pressed in for 10seconds after lighting pilot. After 10seconds, release control knob.Note: If pilot goes out, repeat steps3 through 7.OPERATINGHEATERLIGHTINGINSTRUCTIONSFigure 16 - Control Knob In The OFFPositionControl KnobPiezo Ignitor ButtonFOR YOUR SAFETYREAD BEFORELIGHTINGWARNING: If you do not followthese instructions exactly, a fireor explosion may result causingproperty damage, personal injuryor loss of life.A. This appliance has a pilot which mustbe lighted by hand. When lighting thepilot, follow these instructionsexactly.B. BEFORE LIGHTING smell allaround the appliance area for gas. Besure to smell next to the floor becausesome gas is heavier than air and willsettle on the floor.WHAT TO DO IF YOU SMELLGAS• Do not try to light any appliance.• Do not touch any electric switch;do not use any phone in yourbuilding.• Immediately call your gas supplierfrom a neighbor’s phone. Followthe gas supplier’s instructions.• If you cannot reach your gassupplier, call the fire department.C. Use only your hand to push in or turnthe gas control knob. Never use tools.If the knob will not push in or turnby hand, don’t try to repair it, call aqualified service technician or gassupplier. Force or attempted repairmay result in a fire or explosion.D. Do not use this appliance if any parthas been under water. Immediatelycall a qualified service technician toinspect the appliance and to replaceany part of the control system andany gas control which has been underwater.1. STOP! Read the safety informationabove.2. Make sure manual shutoff valve isfully open.3. Turn control knob clockwiseto the OFF position.4. Wait five (5) minutes to clear out anygas. Then smell for gas, includingnear the floor. If you smell gas,STOP! Follow “B” in the safetyinformation. If you don’t smell gas,go to the next step.5. Press in control knob, and turncounterclockwise to pilotposition. Keep control knob pressedfor five seconds.Note: You may be running thisheater for the first time afterhooking up to gas supply. If so, thecontrol knob may need to bepressed in for 30 seconds. This willallow air to bleed from the gassystem.• If control knob does not pop upwhen released, contact a qualifiedservice person or gas supplier forrepairs.6. With control knob pressed in, pushdown and release ignitor button. Thiswill light pilot. The pilot is attachedto the front of burner. If needed, keeppressing ignitor button until pilotlights.Note: If pilot does not light, referto Trouble Shooting, pages 12through 14. Also contact aqualified service person or gassupplier for repairs. Until repairsare made, light pilot with match,see Manual Lighting Procedure,page 11.Ignitor ElectrodeWARNING: When runningheater, set control knob at LOWor HIGH locked positions. Neverset control knob between lockedpositions. Poor combustion andhigher levels of carbon monox-ide may result.CAUTION: Do not try to adjustheating levels by using themanual shutoff valve.