Desa GN30T Safety Information And Installation Manual

Also see for GN30: Safety information and installation manual Safety information and installation manual Safety information and installation manual

Contents

Desa GN30T Safety Information And Installation Manual Manual pdf 17 page image

www.desatech.com107884-01H 17Figure 22 - Pilot (actual pilot may vary)6. With control knob pressed in, push downand release ignitor button. This will lightpilot. The pilot is attached to the front ofburner. The pilot is attached to the front ofthe burner. If needed, keep pressing igni-tor button until pilot lights.Note: If pilot does not stay lit, refer toTroubleshooting, pages 20 through 23. Alsocontact a qualified service person or gassupplier for repairs. Until repairs are made,light pilot with match. To light pilot withmatch, see Manual Lighting Procedure.7. Keep control knob pressed in for 30 sec-onds after lighting pilot. After 30 seconds,release control knob.• If control knob does not pop up when re-leased, contact a qualified service personor gas supplier for repairs.Note: If pilot goes out, repeat steps 3through 7. This heater has a safety inter-lock system. Wait one (1) minute beforelighting pilot again.8. Turn control knob counterclockwiseto desired heating level. The main burnershould light. Set control knob to any heatlevel between 1 and 5.CAUTION: Do not try to ad-just heating levels by using theequipment shutoff valve.OPERATING HEATERContinuedIgnitor ElectrodePilot BurnerThermocoupleTO TURN OFF GASTO APPLIANCEShutting Off Heater1. Turn control knob clockwise to theOFF position.2. Turn off all electric power to the applianceif service is to be performed.Shutting Off Burner Only (pilot stays lit)Turn control knob clockwise to the PI-LOT position.THERMOSTAT CONTROLOPERATIONThe thermostatic control used on these modelsdiffers from standard thermostats. Standardthermostats simply turn on and off the burner.The thermostat used on this heater senses theroom temperature. The thermostat adjusts theamount of gas flow to the burner. This increasesor decreases the burner flame height. At timesthe room may exceed the set temperature. If so,the burner will shut off. The burner will cycleback on when room temperature drops belowthe set temperature. The control knob can beset to any heat level between 1 and 5. Selectingthe 5 setting will cause the burner to remain fullyon without modulating down in most cases.Note: The thermostat sensing bulb measuresthe temperature of air near the heater cabinet.This may not always agree with room tempera-ture (depending on housing construction, instal-lation location, room size, open air tempera-tures, etc.). Frequent use of your heater will letyou determine your own comfort levels.MANUAL LIGHTINGPROCEDURE1. Remove front panel (see Figure 7, page 9).2. Follow steps 1 through 5 under Lighting In-structions, pages 16 and 17.3. With control knob pressed in, strike match.Hold match to pilot until pilot lights.4. Keep control knob pressed in for 30 secondsafter lighting pilot. After 30 seconds, releasecontrol knob. Now follow step 8, under Light-ing Instructions, pages 16 and 17.5. Replace front panel.