Desa GWN6 Installation Manual

Also see for GWN10: Safety information and installation manual Installation manual Safety information and installation manual Installation manual

Contents

Desa GWN6 Installation Manual Manual pdf 13 page image

www.desatech.com 13117001-01EFigure 19 - PilotLIGHTINGINSTRUCTIONS1. STOP! Read the safety information,page 12.2. Make sure equipment shutoff valve is fullyopen.3. Turn off any electric power to the appli-ance if service is to be performed.4. Turn control knob clockwise to theOFF position.5. Wait five minutes to clear out any gas.Then smell for gas, including near thefloor. If you smell gas, STOP! Follow “B”in the safety information, page 12. If youdon’t smell gas, go to the next step.6. Thermostat Models: Turn control knobcounterclockwise to the PILOTposition. Press in control knob for five (5)seconds.Manual Models: Press in and turn controlknob counterclockwise to the PI-LOT position. Keep control knob pressedin for five (5) seconds.7. With control knob pressed in, push downand release ignitor button. This will lightpilot. The pilot is attached to the front ofburner. Note: You may be running thisheater for the first time after hooking up togas supply. If so, you may need to press incontrol knob for 30 seconds or more. Thiswill allow air to bleed from the gas system.If needed, keep pressing ignitor button untilpilot lights. If ignitor does not light pilot, re-fer to Troubleshooting, page 16 or contact aqualified service person or gas supplier forrepairs. Until repairs are made, light pilotwith match. To light pilot with match, seeManual Lighting Procedure, page 14.8. Keep control knob pressed in for 30 sec-onds after lighting pilot. After 30 seconds,release control knob.• If control knob does not pop up whenreleased, contact a qualified serviceperson or gas supplier for repairs.Note: If pilot goes out, repeat steps 4 thru7. Thermostat models have a safety inter-lock system. Wait one (1) minute beforelighting pilot again.9. Turn control knob counterclockwiseto desired heating level. The main burnershould light. Manual control heatersshould be used in locked positions.Figure 17 - Control Knob In the OFFPosition for Manual Control ModelsFigure 18 - Control Knob In the OFFPosition for Thermostat ModelsOFLOTControlKnobIgnitorButtonOPERATIONContinuedIgnitor Button ControlKnob10. To turn off burner only and leave pilot lit,turn control knob clockwise to thePILOT position.WARNING: Always operatemanual control heaters at thelocked positions. Operationbetween these positions maycreate a possible health hazardif used in a poorly ventilatedroom. Read owner’s manual forcomplete instructions.CAUTION: Do not try to ad-just heating levels by using theequipment shutoff valve.TO TURN OFF GASTO APPLIANCEShutting Off Heater1. Turn control knob clockwise to theOFF position.2. Turn off all electric power to the applianceif service is to be performed.3. Close equipment shutoff valve (see Figure14, page 12.Thermocouple Ignitor ElectrodePilot Burner