Desa H) AND VM42EP(B Owner's Operation And Installation Manual

Also see for H) AND VM42EP(B: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com108796-01K 176. Repeat the process for the opposite doorassembly.7. To adjust the doors, slide them partially open.Using a screwdriver, loosen the hold-downscrews in the spring clip (see Figure 34) andpivot plate.8. Close both doors until evenly joined at themiddle and note the gap at the outer edges ofthe face.9. Reopen one door at a time and retighten theupper and lower hold-down screws.10. Repeat the process until both doors are evenlyjoined, spaced and working freely.CAUTION: The glass pan-els become very hot while theappliance is operating. Do notattempt to adjust or clean theglass doors until the appliancehas fully cooled.The doors may be removed for replacement orcleaning as follows:1. Partially open the door and press up on theupper spring clip with a screw driver until theouter top pivot pin is free of the clip.2. Fully fold the frame assembly and slide theupper edge towards the center of the fireboxopening until the guide pins are free of theframe rail (see Figure 35).CAUTION: Always operatethe appliance with the doors ei-ther fully opened or fully closed.Operating the appliance withthe doors partially open can re-sult in improper venting of flueproducts.INSTALLATIONContinuedFigure 34 - Adjusting Glass DoorsSpringClipHold-DownScrewSideFrontFacePartiallyOpenedDoorFigure 35 - Removing Glass DoorsSpring ClipDepressSpring Clipto ReleasePivot PinRemove Bottom PinFrom Pivot Plate WhileSliding Door Out of theUpper TrackPivot PlateFold Bi-FoldDoor AfterReleasingSpring Clipand SlideDoor Out ofUpper TrackOPENING VENT DAMPERVent damper must be locked in the full open posi-tion before operating the fireplace. If vent damperis not open, fireplace will not light.CLOSEOPENVENT DAMPER MUST BE LOCKEDIN THE FULL OPEN POSITIONTO OPERATE THE APPLIANCEFigure 36 - Opening Vent Damper