Desa INTERNATIONAL UNVENTED (VENT-FREE) GAS LOG HEATER Owner's Operation And Installation Manual

Also see for CGX3924NR: OWNER'S OPERATION AND INSTALLATION MANUAL Operation and installation manual

Desa INTERNATIONAL UNVENTED (VENT-FREE) GAS LOG HEATER Owner's Operation And Installation Manual Manual pdf 21 page image

108114For more information, visit www.desatech.comFor more information, visit www.desatech.com2121Figure 38 - Pilot (Propane/LP)Ignitor ElectrodePilot BurnerThermocoupleFigure 39 - Pilot (Natural)IgnitorElectrodePilot BurnerThermocoupleShutting Off Heater1. Turn control knob clockwise to the OFF position.2. Turn rear burner control knob clockwise to theOFF position.3a. Set selector switch in the OFF position.3b. If Using Optional Hand-Held Remote: Set selector switchin the OFF position to prevent draining battery.Shutting Off Burners Only (pilot stays lit)You may shut off the burners and keep the pilot lit by doing oneof the following:1. Turn control knob clockwise to the PILOT position.2. Turn rear burner control knob clockwise to theOFF position.3. Use remote control manual OFF button.4. Set selector switch in the OFF position.1. Follow steps 1 through 6 under Lighting Instructions, page 20.2. Depress control knob and light pilot with match.3. Keep control knob pressed in for 30 seconds after lightingpilot. After 30 seconds, release control knob. Now followsteps 9 through 12, Lighting Instructions, column 1.TO TURN OFF GAS TO APPLIANCEMANUAL LIGHTING PROCEDURECAUTION: Do not try to adjust heating levels byusing the equipment shutoff valve.7. With control knob pressed in, press and release ignitor but-ton. This will light pilot. The pilot is attached to the frontburner. If needed, keep pressing ignitor button until pilot lights.Note: If pilot does not stay lit, contact a qualified serviceperson or gas supplier for repairs. Until repairs are made,light pilot with match. To light pilot with match, see ManualLighting Procedure.8. Keep control knob pressed in for 30 seconds after lightingpilot. After 30 seconds, release control knob.• If control knob does not pop out when released, contacta qualified service person or gas supplier for repairs.Note: If pilot goes out, repeat steps 4 through 8.9. Slightly push in and turn control knob counterclockwiseto the ON position.10. Wait one minute and switch selector switch to the ON posi-tion to light burner.Note: AUTO is only functional whenusing GWMT1 or GWMS2 optional accessories.11. Set flame adjustment knob to any level between HI and LO.12. To light the rear yellow flame burner, push in and turnrear burner control knob counterclockwise to theON position.WARNING: Make sure the selector switch is in theOFF position when you are away from home for longperiods of time. Heater will come on automaticallywith selector switch in the ON position.OPERATING HEATERContinuedOFFPILOTONLOHIAUTOOFFONFigure 37 - Control Knobs and Ignitor Button Locations (Shownas Supplied, No Remote Control Operation)Rear BurnerControl KnobSelectorSwitchIgnitor ButtonControl KnobFlameAdjustmentKnobOPERATING HEATER (REMOTE-READY MODELS)Lighting Instructions (Cont.)To Turn Off Gas To ApplianceManual Lighting Procedure